Dormakaba 79 Series Installation Sheet

790/79 Series Rework Installation Sheet Current PCB Switch Holder New Cam Protective Bracket New privacy Switch New PCB 1 4 6 A B C D 5 2 3 Remove screw and take out battery pack Remove foam, cam & screws and disconnect cables Assemble New PCB Option Option Option Motor (See step 4) Pass cables in housing gap push cables away from the screw head Place the plastic clip to hold the cables in place. Make sure the clip is not on the cables before to hold it with the screw Before placing PCB connect stan- dard cables and cables for door option if applicable at orientation as shown Use screws from step 4 Override Switch (See step 4) Remove PCB Remove 5 screws and take off the back plate Assemble protective bracket and hold with one of the 5 screws from step 2 Screw below center label Protective Bracket 790/79 Series LOCK PCB + PRIVACY MECH. PARTS PK3612_03_19

Location as shown Assemble new cam. Move switch lever (see arrow) first and assemble cam after Remove protective bracket Assemble back plate with 5 screws Assemble battery pack with screw Assemble the switch holder, pass the wires underneath it. Make sure the screw head is underneath as shown. Assemble privacy switch on switch holder Switch lever orientation Screw Head Place Cam orientation as shown Align cam & back plate Pass cables through back plate hole Side contact Be careful that the spring does not jump and is still in its position Align marks 790/79 Series Rework Installation Sheet PK3612_03_19