eTIGER ES-S6A Manual
Text of the manual
The ES-S6A can be used either as an additional siren connected to your alarm
system or as an independent siren connected to a remote control and/or wireless
detectors.
-
Wireless connection for an easy installation
-
Radio-frequency security of the accessories: more than one million of codes
combinations
-
Simplified connection to accessories
-
Can
Switch / Power
Connect
General information
The ES-S6A is powered by its built-in AC 110-220V plug.
Several ES-S6A can be installed throughout your home and connected to your
alarm system. When the alarm of your system is triggered, the ES-S6A rings out
and its LEDs switch on.
The ES-S6A can also be used as a standalone siren and can be connected to
wi
Power on / off
Power on
The siren is powered off as per default settings. Plug the siren to a 110-220V socket.
You hear a long beep: the siren is on. You can also turn the siren on by long pressing
(6 seconds) the Power button on the siren.
Enter Setup Mode / Power off
Enter Setup Mode by pressing the Power button once. Press again the Power button for 6
sec
Use as an additional siren
If the siren is used as an additional siren, it must be registered to your alarm’s control
panel. If the alarm is triggered, the ES-S6A will ring out and its LED lights will turn on.
Register the ES-S6A in the control panel
Press the Connect button on the siren. The siren beeps once and the LEDs light up:
the siren is now in Conn
