Kawasaki Mule SX Assembly Instructions
Read Online
Read the Kawasaki Mule SX Assembly Instructions online using the built-in PDF viewer.
Text of the manual
Improper installation of this accessory could result in an accident causing serious bodily injury or death.
To prevent an accident, be sure that this accessory is properly and securely installed on your vehicle. If
you cannot properly install this accessory yourself, have a professional installer, such as an authorized
Kawasaki dealer, install it for you.
Prior to each use, check to be sure the accessory is securely attached to the vehicle and periodically
inspect the accessory for any required adjustment, wear, and damage.
Model
MULE SX
Part Number
99994-0734
Description
Brush Guard
Approx. Assembly
Time
30 Minutes
WARNING
Description
Guard
Clamp
Bolt, M8 x 16 mm
Washer, M8
Self Tapping Bolt, M8 x 20 mm
© 2016 Kawasaki Motors Corp., U.S.A.
Page 1 of 2
inst-99994-0734_rev02
1. Park the vehicle on level ground, set the parking brake, turn off the ignition switch.
5. Finish tightening self tapping bolts (A05).
Please check / adjust all screws in regular intervals.
4. Attach each clamp (A02) by first inserting tab of clamp into slot on the guard (A01). Using one bolt (A03) and
one washer (A04), tighten each clamp to 16.5 N-m (18 ft-lb)
2. Before installing the guard, install the self tapping bolts (A05) into the factory bumper. After all four bolts are
installed and the holes are tapped, remove the self tapping bolts.
3. Set the guard (A01) into position on factory bumper. Loosley install four self tapping bolts (A05).
FRONT VIEW
REAR VIEW
Page 2 of 2
inst-99994-0734_rev02
