Cisco WS-C3750G-24TS-S1U - Catalyst Switch - Stackable Getting Started Manual

Catalyst 3750 switch Console cable (optional) Two 19-inch mounting brackets Four number-12 Phillips machine screws Four number-8 Phillips truss-head screws Six number-8 Phillips flat-head screws Four rubber mounting feet AC power cord Connector cover for redundant power system (RPS) Two number-4 pan-head screws Cable guide One black Phillips machine screw Documentation 0.5-meter, 1.0-meter or 3.0-meter StackWise cable 207383 Catalyst 3750G SERIES SYST RPS STAT DUPLX SPEED MODE 1 2 5 6 7 8 9 10 11 12 13 14 15 16 3 4 1X 2X 15X 16X 17 18 21 22 23 24 25 26 27 28 29 30 31 32 ...

• In the Management Interface (VLAN ID) field, the default is 1. Enter a new VLAN ID only if you want to change the management interface through which you manage the switch. The VLAN ID range is 1 to 1001. • In the IP Address field, enter the IP address of the switch. In the IP Subnet Mask field, click the drop-down arrow, and select an IP Subnet Mask. • In the Default Gateway field, enter the IP address for the default gateway (router). • Enter your password in the Switch Password field. The password can be from 1 to 25 ...

Follow these steps: For a list of supported modules, see the release notes on Cisco.com. For detailed instructions on installing, removing, and connecting to SFP modules, see the documentation that came with the SFP module. Caution Removing and installing an SFP module can shorten its useful life. Do not remove and insert SFP modules more often than is absolutely necessary. Verify Port Connectivity After you connect to the switch port, the port LED turns amber while the switch establishes a link. This process takes about 30 seconds. Then the ...

Follow these steps to connect the StackWise cable to the StackWise ports: Caution Removing and installing the StackWise cable can shorten its useful life. Do not remove and insert the cable more often than is absolutely necessary. Note Always use a Cisco-approved StackWise cable to connect the switches. Step 1 Remove the dust covers from the StackWise cables and StackWise ports, and store them for future use. Step 2 Insert one end of the StackWise cable into the StackWise port on the back of the switch. Step 3 Use the window in the StackWise cable to align the c ...

This guide provides instructions on how to use Express Setup to initially configure your Catalyst switch. Also covered are switch management options, basic rack-mounting procedures, stacking procedures, port and module connection procedures, power connection procedures, and troubleshooting help. For additional installation and configuration information for Catalyst 3750 switches, see the Catalyst 3750 documentation on Cisco.com. For system requirements, important notes, limitations, open and resolved bugs, and last-minute documentation updates, see the release notes, also ...

This section describes how to reset the switch by rerunning Express Setup. These are reasons why you might want to reset the switch: • You installed the switch in your network and cannot connect to it because you assigned the incorrect IP address. • You want to clear all configuration from the switch and assign a new IP address. • You are trying to enter Express Setup mode, and the switch LEDs start blinking when you press the Mode button (which means that the switch is already configured with IP information). Caution Resetting the switch deletes the configuration ...