Audix M70WD Installation & Operating Manual

system that is the fast, trouble-free way to stream Audix audio performance through Ethernet networks. Like all Audix products, it is designed to provide many years of reliable service. Please read this user guide prior to installation and use for optimal performance. AIMING THE MICROPHONE The patented swivel mounting system on the M70 can be rotated in any direction and angled up to 30 degrees toward a sound source. 1. To access the microphone capsule, remove the microphone grill by rotating counter-clockwise. 2. Aim the capsule as needed and reinstall the microphone grill. INSTALLATION 1. Determine microphone placement, remove ceiling tile, and drill 2-inch (51mm) hole in the desired location 2. Remove the knurled ring from the M70 module and insert the module through the hole 3. Reinstall the knurled ring and hand-tighten 4. Connect one end of a CAT 5 - 7 cable to the RJ45 jack at the top of the module and one end to the single-element RJ45 jack on the Audix DN4 or DN43 microphone interface 5. The M70WD is equipped with red and green LED status indicators, which can be controlled through available third-party plugins for the Audix DN4 and DN43 Dante® | AES67 microphone interfaces. IN THE BOX • M70WD microphone • Seismic / Fire restraint cable

Attach the restraint cable to the module using the ring connector at one end of the cable. Wrap the cable around a beam, eyebolt or hanger. Next, slip the cable through the top of cable stay barrel pulling g excess cable until taut To release cable, depress the cable release pin on either end to release the loop or to extend cable length. CABLE STAY BEAM, EYEBOLT OR WALL CABLE CABLE RELEASE PIN CABLE STAY BARREL PUSH PIN IN TO RELEASE CABLE

Polar Pattern Cardioid Output Impedance 150 ohms Sensitivity 38 mV / Pa @ 1k Signal to Noise Ratio 72 dB Equivalent Noise Level 22 dB Maximum SPL ≥130 dB Dynamic Range 108 dB Power Requirements 18 - 52V phantom Connector RJ45 Required Cable CAT5-7* Materials / Finish Brass, aluminum and steel / white AudixUSA.com | 800.966.8261 PRODUCT REGISTRATION: Please register your product online at AudixUSA.com/register SERVICE: For service and warranty information, visit AudixUSA.com/service ALL SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. v0.1 08.19 *Audix CAT7 cable is highly recommended. It consists of four twisted pairs that are individually shielded and is optimized for balanced audio and cross-talk elimination. The cable is LS0H (low smoke zero halo- gen) and available in prepackaged lengths or in bulk.