CLASSÉ AUDIO CDP-102 Owner's Manual

仪，将其设定为 C 加权和低速响应，然后伸直� ...

unpacking your player Carefully unpack your disc player according to the supplied instructions, and remove all accessories from the carton. Important! Keep all packing materials for future transport of your Classé Important! Keep all packing materials for future transport of your Classé product. Shipping your new component in anything other than its purpose-designed packing material may result in damage that is not covered by the warranty. placement This disc player has been designed to operate optimally on any stable and level surface. Vibration damping in the feet ...

the video. Audio Delay allows you to compensate for this by inserting a delay that repositions the audio in relation to the video and brings them into sync. The delay is adjustable in 10ms steps and operates within a range of +/- 200 ms digital output The digital outputs can be con–gured in any of three ways, based on how you plan to use the player: • off ƒ for example, if you plan to use only the stereo analog outputs, and off ƒ for example, if you plan to use only the stereo analog outputs, and ...

The front panel Standby button will toggle the player between its fully operational status and a standby mode that leaves the player off, yet ready standby mode that leaves the player off, yet ready standby to respond to system commands via any of the supported control options (e.g. IR input, DC trigger, CAN Bus, or RS-232). The current state of the player is indicated by the LED on the Standby button on the front panel. When the unit is powered and switched on, this LED indicates the following: • On = standby • Flashing (o ...

All speci–cations are accurate at the time of printing. Classé reserves the right to make improvements without notice. ■ Frequency response (Balanced) 8 Hz √ 20 kHz Ø0.1dB (Balanced) 8 Hz √ 20 kHz Ø0.1dB (Balanced) (single ended) 8 Hz √ 20 kHz +0/-0.7dB ■ Distortion (THD+noise) 0.001% (THD+noise) 0.001% (THD+noise) ■ Output voltage (single-ended) 2Vrms (single-ended) 2Vrms (single-ended) ■ Output voltage (balanced) 4Vrms (balanced) 4Vrms (balanced) ■ Signal-to-noise ratio 110dB typical ■ Channel separation better than 115dB ■ D/A Convert ...

setup（系统设置）按钮，将进入对播放机进行各种控制的菜单系统， 而播放机既可以是单独工作的，也可以是整个系统的组成部分。 系统设置的菜单系统 从系统设置菜单可以进入四个子菜单，下面将一一讨论。 音频设置 按下audio setup（音频设置）按钮将进入与播放机处理各种音频的方式 有关的六个控制屏幕。 中文 ...

the appropriate setting based on the level of ambient light typically found in your listening room while using the system. A high brightness setting usually high brightness setting usually high works best in brightly-lit rooms; you may –nd that a lower setting is less visually intrusive under more subdued lighting conditions. timeout If you prefer listening to music in a dimly-lit or darkened room, you may –nd even the low brightness setting of the display somewhat distracting. If so, you low brig ...