Cypress CY3641 Quick Start Manual

CY3641 PROGRAMMING KIT Kit Contents: 1. CY3641 Programming Board 2. USB Standard-A to Mini-B cable 3. Quick Start Guide (this document) 4. IC CY29412FLXI (placed inside the socket) The CY3641 Programming Kit enables quick and easy Programming of Cypress’s High Performance Programmable Oscillator (CY29411, CY29412) • Download and install the latest kit software onto your PC from www.cypress.com/CY364X • Connect the board to your PC using the provided USB cable • The Status LED (Green) turns ON after the kit driver enumeration is complete 1 Steps to successfully program the clock device using this Programming kit. • Ensure default jumpers setting as mentioned in Table overleaf • Run the Clock Programmer software tool 1. Select CY294xx from the Device List 2. Select 0x55 for target I2C address 3. Click Connect 4. Open the JEDEC fle from \CY364x Programming Kit\\Firmware\ CY3641\CY3641 Kit LVPECL 2.5V 156.25MHz) 5. Click Program • While eFuse programming is underway you will notice Power LED (LED2) to glow Amber 2

CY3641 PROGRAMMING KIT © 2017 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the property of their respective owners. 002-18660 Rev.*A CY3641 Board Details Table: Jumpers Default Position • CY3641 comes with two SMA connectors, which could be used to measure clock parameters of the programmed part • Please refer Section 5 Additional Features of CY3641 in the Kit Guide for details Main Power Supply Jumper (J1) Power LED Pin1 Termination Jumper (J5) Differential Clock Output Socket for 8-pin LCC 7mm x 5mm * Component is on the bottom-side of the Programming Board USB Mini-B Connector Status LED PSoC 5LP (CY8C5868LTI-LP039)* Purpose Power on CY29412 Jumper J1 Default Position 1 - 2 1 - 2 Termination voltage set to GND J5 3