AsReader ASX-520R Parameter Manual
Text of the manual
AsReader（ASX-520R & ASR-020D）
Barcode Parameter Manual
Asterisk, Inc.
Version 1.1
※The data will be changed without a notice.
This document describes the programmable parameters, provides bar codes for programming, AsReader is
shipped with the factory default settings. These factory default values are stored in non-volatile memory
and are preserved even when the scan engine is powered down. Changes to the factory default values are
also stored in non-volatile memory and are preserved even when the scan engine is powered down. Scan the
appropriate bar codes included in this document. The new values replace the existing memory values. The
factory default parameter values can be recalled by scanning Set Factory Defaults.
16 March 2015
First Rivision
1.1
16 June 2016
A-1 Fix tipographical error at Parameter Defaults
B-13 Delete Decode LED Behavior
B-16 Delete “Host” from Trigger Mode
B-11 Add Decode Aiming Pattern
B-13 Add Decoding Illumination
To set the parameter
Charge the battery of AsReader, before setting the parameters.
Changing Default Values
The decoder ships with the settings shown in the Table on page A-1. If the default
values suit requirements, programming is not necessary.
Scan the appropriate barcodes in this guide to change a parameter value.
These new values replace the standard default values in memory.
To return all features to default values, scan Restore Defaults on page B-1. Throughout
the programming barcode menus, asterisks (*) indicate default values.
Parameter Default setting (factory default)
Parameter
Value
Page
User Preferences
Default parameter
Restore Defaults
B-1
Parameter Scanning
Enable
B-2
Lock Parameter Scanning
Disable
B-3
Unlock Parameter Scanning
Disable
B-3
User Parameter Pass Through
Disable
B-4
Beep After good Decode
Enable
B-5
Beeper Tone
Medium
B-6
Beeper Volume
High
B-7
Beeper Duration
Medium
B-8
Suppress Power-up Beeps
Do not suppress
B-9
Aim Brightness (Aiming LED)
High
B-10
Decode Aiming Pattern
Enable
B-11
Illumination Brightness (Illumination LED)
7
B-12
Decoding Illumination
Enable
B-13
Decode Blinks
Disable
B-14
Decode Blink Duration
Timeout Between
Decodes, Different
Symbols value
B-15
Trigger Modes
Level
B-16
Power Mode
Low Power
B-18
Time Delay to Low Power Mode
1.0 Sec
B-19
Picklist Mode
Disabled Always
B-20
Decode Session Timeout
9.9 Sec
B-21
Timeout Between Decodes, Same Symbol
0.6 Sec
B-22
Timeout Between Decodes Different Symbol
0.2 Sec
B-23
Continuous Barcode Read
Disable
B-24
Unique Barcode Reporting
Disable
B-25
Low Light motion Detection Assist
Disable
B-26
Presentation Mode Field of View
Medium Field of View
B-27
Fuzzy 1D Processing
Enable
B-28
Mirrored Image
Disable
B-29
Mobile Phone/Display Mode
Disable
B-30
Validate Concatenated Parameter Bar Codes
Disable
B-31
PDF Prioritization
Disable
B-32
PDF Prioritization Timeout
200 ms
B-33
Miscellaneous Scanning Parameters
Transmit Code ID Character
None
B-34
Prefix Values
B-35
Suffix Value 1
Suffix Value 2
B-35
Scan Data Transmission Format
Data as is
B-36
Transmit “No Read” Message
Disable
B-38
Report Version
B-39
Report Decoder Manufacturing Information
B-39
Report Scan Engine Manufacturing Information
B-39
