Festool TOPROCK BT 20 Instruction Manual

Manuals+ User Manuals Simplified. FESTOOL TOPROCK BT 20 Instruction Manual Home » FESTOOL » FESTOOL TOPROCK BT 20 Instruction Manual TOPROCK BT 20 Festool GmbH Wertstraße 20 D-73240 Wendlingen +49 (0)7024/804-0 www.festool.com 722042_A / 2020-06-19

1 Symbols 2 Safety warnings 2.1 Preventing damage to the battery 2.2 If a battery has been damaged 2.3 Safe handling of the machine 2.4 Information on charging the machine 3 Operation 4 Intended use 5 Technical data 6 Service and maintenance 7 Transportation 8 Environment 9 General information 9.1 Bluetooth ® 9.2 Federal Communications Commission (FCC) Interference Statement 9.3 RSS Compliance Statement 9.4 Notes (ISED) 9.5 Radiofrequency (RF) Exposure Information 10 File Downloads 11 References 12 Related Manuals Symbols Warning of general danger Warning of electric shock Read the operating instructions and safety instructions. Do not dispose of it with domestic waste. Do not dispose of it with domestic waste. CE marking: Confirms the conformity of the power tool with the European Community directives. Safety class II Do not operate at high volume over long periods of time! Risk of injury to fingers and hands! Only use and store the battery at temperatures of between -10 °C and +40 °C. Keep away from water – do not immerse in liquids. Make sure that the battery is not subjected to physical blows or impacts.

For indoor use only Energy efficiency label Polarity of the DC plug connector Direct current Alternating current Marks the position of the battery. Safety warnings WARNING! Read all safety warnings, instructions, illustrations, and specifica tions provided with this power tool. Failure to follow all instructions listed below may result in electric shock, fire, and/or serious injury. Save all warnings and instructions for future reference. The warranty expires if you open the machine housing or make any other modifications to the machine. Preventing damage to the battery Cells in lithium-ion batteries are sealed so as to be gas-tight and are non-hazardous provided they are used and handled in accordance with the manufacturer’s instructions. Handle discharged batteries with care. Batteries represent a safety hazard as they can cause a very high short circuit current. Even if Li-ion batteries appear to be discharged, they are in fact never fully discharged and therefore continue to represent a safety hazard. Charge the machine at regular intervals to prevent hazards posed by a deeply discharged battery. Make sure that the battery is not subjected to physical blows or impacts. Impacts and penetrating objects may damage the battery. This may lead to leakages, the generation of heat or smoke, or cause the battery to ignite or explode. Do not expose the device to an extremely high-temperature surrounding environ ment. This may cause the battery to explode or flammable liquids or gases to escape from the battery. Do not open, crush or overheat the machine (for example, also protect it from constant sunlight or naked flames ). Failure to observe these precautions is a fire and explosion hazard and may result in burns. Do not immerse the machine in liquids such as (salt) water. Contact with liquids may damage the battery. This may lead to the generation of heat or smoke, or cause the battery to ignite or explode. Do not continue using the machine. Consult an authorized Festool customer service agent. Do not expose the machine to extremely low air pressure. This may cause the battery to explode or flammable liquids or gases to leak from the battery. If a battery has been damaged Do not use the machine if the battery is damaged or has been modified. Stop using the machine immediately if you notice anything unusual about the battery such as odor formation or the generation of heat. Batteries that are damaged or which have been modified may exhibit unpredictable behavior which could lead to heat and smoke, fire, explosion, or injury. Never use water to extinguish burning Li-ion batteries! Use sand or a fire blanket. There is a risk of vapors being released if the battery is damaged or not used correctly. The vapors may irritate your airways. Seek fresh air and consult a doctor if you feel unwell. Fluid may leak out of the battery if it is used incorrectly. Avoid contact with the fluid. Rinse with water any areas which accidentally come into contact with the fluid. If fluid gets into the eyes, also consult a doctor. Leaking battery fluid can cause skin irritation or burns. Safe handling of the machine Do not use the machine in the rain or in damp surroundings. Moisture in the machine may cause a short circuit and fire. Do not use the machine as a workbench or work surface. Do not stand or sit on the machine. This could damage the battery and result in a fire or explosion. Do not transport sharp, hot or damp objects (liquids, pastes, or similar) in the machine. Only transport objects with a maximum weight of 5 kg and do not over fill the machine. You must be able to close the lid without using force. This could otherwise damage the battery and result in a fire or explosion. Risk of explosion due to improper battery replacement or use of an incorrect battery type. Only Festool customer service agents may replace the integrated battery. Do not dispose of the device or battery in a fire or hot oven, and do not crush or cut them mechanically; this may cause an explosion. For correct disposal, see chapter 8 . CAUTION! The mains plug is used to disconnect the machine from the power supply. The socket should be located near the machine and must be easily accessible at all times. Do not set the machine to a high volume for long periods of time to prevent potential hearing damage. Hands and fingers must not be located between the lid and the bottom section when the machine is open. If the lid falls shut, this may result in injuries to the

Information on charging the machine Only charge the machine with the original mains adapter supplied. There is a risk of fire when using an unsuitable mains adapter. Only charge the machine at a room temperature between 0 °C and 45 °C (32 °F and 113 °F). Operation Detailed information on operation: See the sticker in the lid. Detailed operating instruc​ tions are available for download on the machine page at www.festool.com. Intended use Transporting and storing tools and acces​ stories. Receiving and reproducing Bluetooth ® signals. Charging smart devices via USB 2.0. Use in a system with other Systainers. Connection with another TOPROCK BT 20 (stereo function). Use in a vehicle system. Technical data Bluetooth® speaker TOPROCK BT 20 Output 9 W x 2, THD = 5% @11 V 9 W x 2, THD = 1% @ 19 V Battery 18650 lithium-ion cell battery (3S1P) 10,89 V/3350 mAh Charging time: Approx. 3 hours Battery life Approx. 20 hours at normal volume Bluetooth® Bluetooth® v5.0, Class 2 (+2 dBm typical) Supports AVRCP 1.6 and A2DP 1.3. Audio codec SBC/AAC Range (free field) Approx. 50 metres (160 ft) Maximum transmission power at 2402 MHz ~ 2480 MHz: +4 dBm (Bluetooth® EDR) Speaker Dia. 50 mm (dia. 1 31/32″) 8 ohm 5 W/8 W 4 speakers + bass reflex tube with neodymium magnet DC-IN Dia. 4.8 mm (dia. 3/16″) 19 V USB DC OUTPUT 5 V/1 A with overload protection Maximum load 5 kg (11 lbs) Permitted operating temperature range -10 °C to +40 °C (14 °F to 104 °F) Permitted battery temper​ nature for charging 0 °C to +45 °C (32 °F to 113 °F) Lid weight 2.8 kg (6.2 lbs) Mains power pack BQ30A-1901200 Input voltage 100–240 V Input alternating current frequency 50–60 Hz Output voltage 19 V DC Output current 1.2 A Output 22.8 W Average efficiency in operation 87% Efficiency at low load (10%) 84% No-load power consumption ≤ 0.078 W Service and maintenance Customer service and repairs must only be carried out by the manufac​ turer or service workshops.

Clean the machine with a soft, dry cloth to prevent damage. Do not use solvents. Only an authorized service workshop may replace damaged integrated batteries. Transportation The Li-ion batteries included are subject to the requirements of the legislation on hazardous goods. The user must familiarise themselves with the local regulations prior to transport. Special requirements apply to shipping via third parties (e.g. air transport or haulage) and these must be observed. When preparing the item to be sent, a hazardous goods expert must be consulted. Only dispatch the machine if the battery is undamaged. Observe local regula​ tions when shipping. Observe any further national regulations. Environment Before disposal Qualified specialist only: Remove the integrated battery from the machine. To do so, unscrew the different housing components and remove the battery. Do not dispose of the device in the household waste! Recycle devices, accessories,, and pack aging. Observe applicable national regulations. EU only: In accordance with EU directives on waste electrical and electronic equipment and batteries and accumulators and their imple mentation in national law, faulty or used elec trial equipment, batteries, and battery packs must be collected separately and recycled in an environmentally friendly manner. This machine is labeled with the symbol for the separate collection of waste electrical and electronic equipment (WEEE). This means that this machine must be recycled or disman tled in accordance with European Directive 2012/19/EU to reduce the environmental impact. Another option is to return this machine to authorized collection points or a dealer when purchasing new electrical or electronic equip​ meant. Used or faulty batteries must only be returned to collection points if discharged and secured against short-circuiting (e.g. by insulating the terminals with adhesive tape). The applicable regulations must be observed. Batteries will then be recycled. Information on REACH: www.festool.com/reach General information Bluetooth ® The Bluetooth ® word mark and the logos are registered trademarks of Bluetooth SIG, Inc.; they are used by TTS Tooltechnic Systems AG & Co. KG, and therefore by Festool, under licence. Federal Communications Commission (FCC) Interference Statement NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer once in a residential installation. This equip meant generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interfer ence will not occur n a particular installation. If this equipment does cause harmful interfer ence to radio or television reception, which can be determined by turning the equipment off and on, the ser is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the quip​ ment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. NOTE: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. RSS Compliance Statement This device complies with Industry Canada’s license-exempt RSS. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause unde sired operation of the device. This device has been designed and complies with the safety requirement for RF exposure in accordance with RSS-102, issue 5 for portable conditions. Notes (ISED) This Class B digital apparatus complies with Canadian ICES-003 and RSS-210. Operation is subject to the following two conditions: (1) this device may not cause interference (2) this device must accept any interference, including interference that may cause unde​ sired operation of the device. Radiofrequency (RF) Exposure Information The radiated output power of the Wireless Device is below the Innovation, Science and Economic Development (ISED) radio frequency exposure limits. The Wireless Device should be used in such a manner such that the potential for human contact during normal operation is minimized. File Downloads FESTOOL Instruction Manual TOPROCK BT 20 Download [optimized] Download References Bluetooth® Trademark Related Manuals 1. FESTOOL Cordless Impact Driver Instruction Manual FESTOOL Cordless Impact Driver Instruction Manual Product Overview Symbols Warning... 2. FESTOOL Cordless Plunge-Cut Saw Instruction Manual Eng Original Instructions – Cordless plunge-cut saw Read... 3. MIDLAND BT GO Instruction Manual MIDLAND BT GO Thank you for choosing the Midland BT... 4. Creative BT-W3 Adapter Instruction Manual Creative BT-W3 Adapter Instruction Manual PAIRING CREATIVE BT-W3 IN 3... 5. User Manual JBL Live 400 BT / Live 500 BT Headphones INSTRUCTION MANUAL LIVE400BT / LIVE500BT Quick Start Guide 1. What’s... 6. MobilitySound BT speaker microphone for ICOM/Kenwood/BT Dongle radios Specifications MobilitySound BT speaker microphone for ICOM/Kenwood/BT Dongle radios Specifications