Creality CR-100 Manual Book

本说明书依据CR-1003D打印机编制而成 This guide book is for standard CR-100. 详细使用指南见TF卡 Detailed instructions for user are available on the TF card. Screen Button board USB port Power port TF Slot Extuder Holder Nozzle Power Switch Parameter Model CR-100 Molding Tech. FDM Printing Size 100*100*80mm Printing Speed ≤180mm/s，Normal 30-60MM/S Precision ±0.1mm Layer Thickness 0.1-0.4mm Nozzle Diameter 0.4mm Nozzle Temp. 200℃ Printing Mode TF card One-button Print，offline printing, Remote printing File Format stl，obj，amf Slice Software Creality Slicer/Cura/Simplify3D Power Supply Input:100-240V AC 1.2A 50/60Hz Output:DC 12V 5.0A Total Power 60W Filament φ1.75mm PLA

the right to lock it. 2. Put the filament on the holder. Start/Pause： First Click ：Start to Printing after heating to 200℃ Second Click：Stop printing Third Click：Continue Printing Home：Return to origin Heat/Cool： First Click：Heating to 200℃。 Second Click：Stop to heat, Cooling to room temperature Remote Control Button Panel Load Filament Filament Clip Clip Magnetic Platform Platform Place the magnetic platform on the printing platform, and fix it by clips. 1. Pressing to heat，waiting the tempreature of nozzle to arrive 200℃. 2. Pressing the extrusion clamp, pass the filament through the extruder and PTFE tube into the nozzle, untill the filament overflow *After heating, Press the extrusion clamp, pull out the filament to remove. Load Filament Install Platform 1. Insert the TF card into the TF slot of the printer 2. Click to wait for the nozzle to heat up to 200 ° C 3. Model will be printed after 2 minutes * It only will print the first model in the TF card TF Note In case of emergency, please turn off the power of the 3D printer directly. Please use a 3D printer in a spacious, level, and well ventilated environment. It is recommended that using printer in the temperature of 8℃-40℃ and a humidity of 20% - 50%. outside this range may result in poor printing results. Do not disassemble the 3D printer without permission. If you have any problems, please contact： [email protected] Run “User Guide” in the TF card for more usage information. TF One-button Print