ETC VORA Assembly
Text of the manual
PLACE SEAT ASSEMBLY UPSIDE DOWN ON AN
ELEVATED FLAT SURFACE. POSITION SWIVEL TILT
CONTROL MECHANISM ON BOTTOM SIDE OF
SEAT ASSEMBLY TO MATCH THE INSIDE 4-HOLE
CONFIGURATION.
NOTE: THE SWIVEL TILT CONTROL ADJUSTMENT
KNOB IS TO BE POSITIONED TOWARD THE FRONT OF
THE SEAT. THE FRONT OF THE SEAT IS IDENTIFIED
BY
POSITION THE BACK ASSEMBLY TO THE
CORRESPONDING HOLE CONFIGURATION
ON THE BACK BOTTOM OF THE SEAT
ASSEMBLY. USING THE 5MM HEX KEY
WRENCH, SECURE THE BACK ASSEMBLY
WITH FOUR 5/16-18 X 1 1/4" HEX HEAD BOLTS.
STEP 04
INSERT 5 CASTERS INTO THE PLASTIC BASE.
STEP 03
ORIENT THE GAS LIFT CYLINDER AS
SHOWN AND INSERT THE LARGER END
OF THE CYLINDER INTO THE HOLE IN
THE CENTER OF THE BASE.
STEP 06
CAREFULLY POSITION THE SEAT ASSEMBLY
OVER THE GAS LIFT CYLINDER, ALIGNING THE
HOLE IN THE SEAT CONTROL WITH THE TOP,
SMALLER END OF THE CYLINDER. PRESS THE
SEAT ASSEMBLY ONTO THE CYLINDER
