CommScope CMAX-D-43-UW-i53 Installation Instructions
Read Online
Read the CommScope CMAX-D-43-UW-i53 Installation Instructions online using the built-in PDF viewer.
Text of the manual
Installation Instruction for CMAX Antennas
Page 1
M0149ARA_Installation_CMAX-D-xxx-Antennas
Installation Guide for
CMAX-D-43-UW-i53/CMAX-D-UW-i53/
CMAX-D-TCPUSEi53 Antennas
Note:
Please read the complete description before starting the installation. Make sure
that connectors are properly sealed against water if no cables are connected to
them after installation.
1. Assembly
Fit these seven parts above together and fasten them with screws M4、M6, nuts M4、M6,
spring washers, and washers.
Installation Instruction for CMAX Antennas
Page 2
M0149ARA_Installation_CMAX-D-xxx-Antennas
2. Wall Mounting
1. Use this pedestal piece as a drill jig to mark 4 holes onto the wall as shown in the
drawing above.
2. Drill 4 holes into the wall and insert plastic plug into holes.
3. Attach the complete bracket with taping screw ST4.2X25.
Installation Instruction for CMAX Antennas
Page 3
M0149ARA_Installation_CMAX-D-xxx-Antennas
3. Pole Mounting (30~50 mm pole diameter)
30~50 mm
Installation Instruction for CMAX Antennas
Page 4
M0149ARA_Installation_CMAX-D-xxx-Antennas
4. Antenna Mounting
4.1. Antenna Mounting
4.2. Azimuth Angle
1. Loosen the fixing screw. (Do NOT
unscrew it completely.)
2. Adjust your desired angle. The
complete antenna pedestal can be
swiveled to the left- / right-hand side
by up to 25°.
3. Tighten the fixing screw.
4.3. Elevation Angle
1. Loosen the fixing screw. (Do
NOT unscrew it completely.)
2. Adjust your desired angle. The
complete antenna pedestal can
be swiveled to the top / bottom by
up to 25°.
3. Fasten the fixing screw.
M4 nut
Washer
Spring Washer
Installation Instruction for CMAX Antennas
Page 5
Technical Support:
http://www.commscope.com/wisupport
M0149ARA_Installation_CMAX-
D-xxx-Antennas
List of Changes
Version
Changes
Release Date
M0149ARA
First release
25-July-2019
© Copyright 2019 CommScope, Inc.
All rights reserved.
All information contained in this manual has been revised thoroughly. Yet CommScope accepts no liability for any omissions or faults.
CommScope reserves the right to change all hardware and software characteristics without notice.
Names of products mentioned herein are used for identification purposes only and may be trademarks and / or registered trademarks of
their respective companies.
No parts of this publication may be reproduced, stored in a retrieval system, transmitted in any form or by any means, electronical,
mechanical photocopying, recording or otherwise, without prior written permission of the publisher.
CommScope, 25-July-2019
