Coalesse Denizen Assembly

939500348 Rev B ALLEN WRENCH Denizen™ Round and Oval Table Assembly If you have a problem, question, or request, call your local dealer, or Steelcase Line 1 at 888.STEELCASE (888.783.3522) for immediate action by people who want to help you. (Outside the U.S.A., Canada, Mexico, Puerto Rico, and the U.S. Virgin Islands, call: 1.616.247.2500) Or visit our website: www.steelcase.com © 2016 Steelcase Inc. Grand Rapids, MI 49501 U.S.A. Printed in U.S.A.

939500348 Rev B 1. Place table top (preassembled with PVD lid and liner, if your table has the PVD lid option) face down on the floor (preferably on a carpeted surface to protect from scratching). 2. Place column/base assembly on underside of table, lining it up with pre-drilled holes. On the oval tables, it should be positioned so the base lines up with the top. 3. Place four (4) screws spaced evenly around the column and slowly tighten to make sure that the column is centered on the table top. SCREW

939500348 Rev B 4. Once the four (4) screws are tightened into place, screw in the remaining eight (8). 5. Flip the table over so that it is upright. 6. Adjust the leveling glides by tipping the table and backing the glides out of their holes until the table is level.

939500348 R ev B 1 3 2 PVD MOUNTING B R ACK E T ALLE N HE AD S CR E W NOTE : This view is looking up underneat the worksurface. The PVD mounting bracket is still in place so there is no way you can install the bracket from underneath the worksurface. This view is presented only for illustrative purposes. PVD Installation 1. Open PVD (power/voice/data) lid by pressing down on the lid so that it pops open (touch latch). 2. Take PVD mounting bracket and pass it through the hole in the center of the table. 3. On the left and right of the PVD lid, there should be four (4) Allen head screws mounted on the underside of the table. The keyhole slots on the PVD mounting bracket should slide over these. 4. With the PVD mounting bracket in place, tighten all four (4) Allen head screws with and Allen wrench.

939500348 Rev B 5. Remove insert in PVD liner by pressing down on the edges closest to the PVD mounting bracket (5a) and twisting clockwise (5b) until tabs come out the slot to the side (5a). Push insert to the side of the PVD liner. 6. Take PVD unit and snap it into the mounting bracket (6a). Make sure it is centered in the bracket so that it can snap in all the way. Make sure the cord tucks into the slot in the PVD liner as well (6b). Repeat steps 2 thru 6 for installation of second PVD. 7. Route the power cords through the hole in the bottom of the PVD liner and through the column.

939500348 Rev B 8. Once the PVD units are in place, move the insert in the PVD liner back into position so that the tabs are in the slots. Press down on the insert near the tabs (8a) and rotate it counter-clockwise (8b) so that they snap into the detents on the side. 9. Tip the table on its side, and pull the power cords through the hole in the base and out through one of the wire routing cutouts on the side of the base. CUTOUTS IN BASE