Compaq 234664-002 - ProLiant - ML330T02 Setup And Installation Manual

Compaq Confidential – Need to Know Required This appendix includes the following topics: I LEDs There are several LEDs located on the front, the back, and the inside of your server. These LEDs can communicate the current status of your server components and operations, thus aiding you in diagnosing the problem. You are provided with an illustration of the location of each LED on your server, as well as an explanation of uses and possible statuses in the following section. I Switches There are three switchbanks in your se ...

Compaq Confidential – Need to Know Required The ATA cable shown in Figure 4-8 is included with the ProLiant ML330e server. 1 2 Figure 4-8. Identifying the ATA cable components
Connector for device 0 (primary drive)  Connector for device 1 (secondary drive) ...

Compaq Confidential – Need to Know Required Server Feature Board Components (ProLiant ML330e Server) Figure 1-7 and Table 1-6 show the components of the Server Feature Board for the ProLiant ML330e server with a standard integrated dual-channel ATA/100 controller. NOTE: For Server Feature Board components for the ProLiant ML330 server, refer to Figure 1-6 and Table 1-5 in the preceding section “Server Feature Board Components (ProLiant ML330 Server)”. 6 7 8 9 10 5 4 3 1 2 Figure 1-7. Identifying Server Feature Board components (ProLiant ML330e server) Table 1-6 Se ...

Compaq Confidential – Need to Know Required Reserved Processor Switch (SW1) IMPORTANT: The function of the reserved processor switch is not applicable to the ProLiant ML330e/ML330 server. 1 2 3 4 on Figure E-4. Processor configuration switch (SW1) Table E-4 Processor Configuration Switch (SW1) Settings Position Default Function/Description 1 Off Reserved 2 Off Reserved 3 Off Reserved 4 Off Reserved ...

Compaq Confidential – Need to Know Required 3. Slide the drive into the drive bay, as shown in Figure 3-17. Figure 3-17. Installing a tape drive 4. Connect the data and power cables to the back of the drive, as shown in Figure 3-14. 5. Remove the two bezel blanks in the front bezel in front of the tape drive. See “Removing the Bezel Blanks” earlier in this chapter. 6. Replace the access panel and the front bezel. 7. Restore power to the server. ...

Compaq Confidential – Need to Know Required Removing a Drive Tray NOTE: The drive trays in the removable media bays can be used to mount internal 3.5-inch hard drives. The rails mounted inside the drive trays can be removed and used to mount other devices in the removable media bays. To remove a drive tray from a removable media bay: CAUTION: To prevent damage to equipment or loss of information, make sure that the server is powered down, all cables are disconnected from the back of the server, and the power cord is disc ...

Appendix E LED Indicators, Switches, and Jumpers This appendix provides specific troubleshooting information for the Compaq ProLiant ML330e/ML330 server and is to be used to find details about server startup problems, switch settings, LEDs, and more. For information about general troubleshooting techniques, diagnostic tools, error messages, and preventative maintenance, refer to the Compaq Servers Troubleshooting Guide, also included in your user documentation. When you add or remove a component or change a security feature, you must reconfigure th ...