Compaq AP500 - Professional - 128 MB RAM Reference Manual

Writer: B J Pereira Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-001 File Name: Q-APPE Last Saved On: 5/20/98 3:56 PM COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED Installation Procedures The battery that came with the workstation is permanently installed on the system board. If the original battery becomes inoperative, you must install a second battery. WARNING: The system board contains a lithium battery. The lithium battery may explode if mistreated. The battery is soldered in place and may not be removed. Do not abuse o ...

Writer: B J Pereira Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-001 File Name: G-CH06 Last Saved On: 5/20/98 3:38 PM COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED Installation Sequence This chapter begins with an overview of the installation and configuration sequence. Follow this sequence of steps to ensure the proper installation of any optional equipment. Before you begin, observe the following precautions: WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system components to co ...

Writer: bjpereira Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-001 File Name: D-CH03 Last Saved On: 5/21/98 3:08 PM COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED Disabling Diskette Boot or Diskette Write IMPORTANT: If you disable the diskette drive, the FailSafe Boot Block ROM ignores the disabled component to accommodate a system ROM recovery in the event a system ROM failure occurs. To disable the factory settings (that is, to prevent boot from a diskette or prevent save to a diskette), follow t ...

File Name: I-CH08 Last Saved On: 5/20/98 3:39 PM COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED Removing a Cooling Shield for a Hard Drive Installation A cooling shield covers bays 5 and 6 to provide proper cooling and EMI protection. To remove a cooling shield: 1. Turn off the workstation and disconnect the power cord from the grounded AC outlet and the back of the workstation. 2. Remove the side access panel and front bezel. 3. Refer to the following illustration to remove ...

Writer: B J Pereira Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-001 File Name: A-FRNT Last Saved On: 5/21/98 3:11 PM COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED Symbols on Equipment These icons may be located on equipment in areas where hazardous conditions may exist. Any surface or area of the equipment marked with these symbols indicates the presence of electrical shock hazards. Enclosed area contains no operator serviceable parts. WARNING: To reduce risk of injury from electrical shock hazard ...

Writer: B J Pereira Project: Compaq Professional Workstation AP500 Reference Guide Comments: 338521-001 File Name: A-FRNT Last Saved On: 5/21/98 3:11 PM COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED Appendix A Regulatory Compliance Notices Federal Communications Commission Notice ................................................................... A-1 Class A Equipment............................................................................................................ A-1 Class B Equipment...................................... ...

File Name: I-CH08 Last Saved On: 5/20/98 3:39 PM COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED 3 3 1 2 Figure 8-10. Reinstalling the removable hard drive cage Figure 8-11. Connecting the signal and power cables 5. Reassemble the workstation. ...