Clare Controls ClareVision Plus Operation & User’s Manual

139 10. Install the inner black liner back to the camera. 11. Align the lower dome with the camera. 12. Tighten the screws to secure the lower dome with the camera. Image and focus adjusting To adjust image and focus: 1. Make the three-axis adjustment. 2. View the camera image using the monitor. 3. Rotate the panning table to adjust the panning position of the camera. 4. Rotate the tilting axes to adjust the tilting position of the camera. 5. Rotate the lens table to adjust the azimuth angle of the image. To adjust zoom and focus: 1. View the camera image us ...

Video Standard: Select 50 Hz or 60 Hz. Choose based on video standards; 50 Hz for the PAL standard and 60 Hz for the NTSC standard. Capture Mode: Select the video input mode to meet the varying demands of field of view and resolution. Lens Distortion Correction: When set to on, a distorted image cause by a wide-angle lens is corrected. Configuring OSD Settings You can customize the camera name and time displayed on the screen. To configure OSD settings: 1. Enter the OSD Settings interface. Configuration > Image > OSD Settings 2. Select the corresponding c ...

4. Click Draw Area, and then click and drag the mouse on the live video image to draw a motion detection area. 5. Click Stop Drawing to finish drawing. – or – Click Clear All to clear all areas without saving. 6. (Optional) Move the Sensitivity slider to set the detection sensitivity. To set the arming schedule for motion detection with normal configuration: 1. Click Arming Schedule. 2. Click the time bar, and then drag the mouse to select the time period. 3. Click Delete to remove the current arming schedule, or click Save. Note: 8 periods can be con ...

VCA configuration Video content analysis (VCA) is available in most Clare Vision Plus cameras. VCA gives the camera the ability to analyze and detect information about the video recording. Behavior analysis When the analysis detects suspicious behavior, an alarm can be triggered. VCA information There are several analysis algorithms. Note: Verify that the desired rules are enabled. Browse to Rules. Configuration > Local Configuration > Rules Display Information: The settings below modify the display of the image/live video. Display Target into. on Alarm ...