Akytec MV210-221 Operation & User’s Manual

6 Configuration 6.1 Connection to akYtec Tool Pro The Module is configured in the akYtec Tool Pro program. The Device can be connected to a PC using the following interfaces: – USB (microUSB), – Ethernet. To select an interface: 1. Connect the module to the PC using a USB cable or Ethernet interface. NOTICE If the module is connected to the USB port, the main module power supply is not required. In case of connecting via Ethernet interface it is necessary to s ...

21 akytec GmbH - Vahrenwalder Str. 269 A - 30179 Hannover - Germany Tel.: +49 (0) 511 16 59 672–0 - www.akytec.de Parameter Type Size Comment Parameter Status binary data 1 byte parameter status in the log file (0 – the parameter value is correct, 1 – the parameter value is incorrect and its further processing is not recommended). Line break binary data 2 bytes \n\r (0x0A0D) Example of decrypted entry: 0x52 0x82 0xD1 0x24 0x3B 0x30 0x30 0x30 0x30 0x61 0x39 0x30 0x30 0x3B 0x30 0x30 0x30 0x30 0x30 0x30 0x30 0x31 0x3B 0x31 0x0A 0x0D where – 0x52 0x82 0xD1 0x24 ...

3 Installation Module is to install in the electrical cabinet. The design of the cabinet must protect Module from moisture, dirt and foreign objects. To install Module: 1. Make sure that there is enough free space to connect the wire harness. You need 50 mm above the Module and below it. 2. Fasten the Device to the DIN rail or to a vertical surface using screws (see Figure 3.1). Fig. 3.1 Proper installation Fig. 3.2 Improper installation CAUTION Long-term operation ...

Fig. 7.2 Battery replacement 7. Replace the battery. Recommended time for replacing the battery is not more than 1 minute. If the battery is missing for a longer time, the real-time clock must be set up again. 8. Assembly and installation should be carried out in the reverse order. NOTICE Do not use a different type of battery. When installing the battery, observe the polarity. After Module is assembled and turned on, make sure that the system time is correct. If ne ...