Belden Grass Valley KALEIDO-X16 Installation & Service Manual

4 Frame Operation and IP Network Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 Card Interfaces and Troubleshooting. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 Networking Essentials . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

pair 1) Cable length 100 m (328 ft) (Belden 1694A) Alignment jitter(100 KHz) < 0.2 UI p-p Connectors BNC 3G-SDI Monitoring Outputs Signal 4:2:2 SMPTE ST 424:2006 (2.97 Gbps / 2.97/1.001 Gbps) Formats (Level A only) 1080p50 1080p59.94 Audio SMPTE ST 299-1 (limited to one pair, embedded on group 1, pair 1) Cable length 100 m (328 ft) (Belden 1694A) Return loss > 15 dB up to 1.5 GHz > 10 dB up to 2.9 ...

2 Upgrade your multiviewer’s Kaleido Software and firmware from the USB key (see Upgrading the Kaleido Software and Firmware, on page 109). 3 Verify the version number to confirm that the upgrade was successful (see Verifying the Version Number, on page 111). Preparing a USB Key To copy all files required for the upgrade to a USB key 1 Download the update files onto your PC’s hard drive. See Software and Firmware Updates, on page 15. 2 Insert a USB key into one of your PC’s USB ports. 3 Locate and open the Kaleido Software Upgrad ...

The pinout of the Audio I/O terminal block adapter (TBA) depends on whether you have a single-head or dual-head Kaleido-X16 model. Audio I/O TBA Pinout on the Kaleido-X16-D The Audio I/O TBA pinout on the Kaleido-X16-D is as follows: Bottom row Center row Top row 19 GND 10 AES Out 1 (+) 1 AES Out 1 (-) 20 GND 11 AES Out 2 (+) 2 AES Out 2 (-) 21 GND 12 GND 3 GND 22 GND 13 Analog Left Out 1 (+) 4 Analog Left Out 1 (-) 23 GND 14 Analog Right Out 1 (+) 5 Analog Right Out 1 (-) 24 GND 15 Analog Left ...

limitations: • Full screen layouts are not supported. • Changing a display resolution from the monitor wall menu is not supported and will break the underlying cluster’s integrity. You must use XEdit to configure the display resolution (see “Changing Room Display Resolutions” in the Kaleido Software User’s Manual; see Related Documentation on page 15). In the advent that such a change was made by mistake, you will have to repair the broken ...

4 Frame Operation and IP Network Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 Card Interfaces and Troubleshooting. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 Networking Essentials . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...