Artec Avenue 50 Quick Start Manual

DO NOT OPEN IMPORTANT SAFETY INSTRUCTIONS - DO NOT OPERATE NEAR ANY HEAT SOURCE AND DO NOT BLOCK ANY VENTILATION OPENINGS ON THIS APPARATUS. - ONLY CONNECT POWER CORD TO A POLARIZED, SAFETY GROUNDED OUTLET WIRED TO CURRENT ELECTRICAL CODES AND COMPATIBLE WITH VOLTAGE, POWER, AND FREQUENCY REQUIREMENTS STATED ON THE REAR PANEL OF THE APPARATUS. - ONLY USE ATTACHMENTS, ACCESSORIES, STANDS, OR BRACKETS SPECIFIED BY THE MANUFACTURER FOR SAFE OPERATION AND TO AVOID INJURY. - WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK OR FIRE, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. - SERVICE MUST BE PERFORMED BY QUALIFIED PERSONNEL. - OUR AMPLIFIERS ARE CAPABLE OF PRODUCING HIGH SOUND PRESSURE LEVELS. CONTINUED EXPOSURE TO HIGH SOUND PRESSURE LEVELS CAN CAUSE PERMANENT HEARING IMPAIRMENT OR LOSS. USER CAUTION IS ADVISED AND EAR PROTECTION IS RECOMMENDED IF UNIT IS OPERATED AT HIGH VOLUME. GAIN GAIN MIXER GAIN LEVEL MIDDLE BASS TREBLE REVERB POWER AMP*** CD / MP3 IN REC OUT / PHONE DRIVE FOOT SW MIDDLE BASS TREBLE TIME LEVEL MASTER VOLUME SPEAKER General microphone Preamp equipped Acoustic guitar Humbucker or active pickup Single pickup Gain setting Drive setting Reverb setting Heavy Metal Blues O.D Rock Distortion Crunch Distortion Reverb Room reverb Hall reverb SETTING GUIDE DC POWERED STREET BAND AMPLIFIER GAIN MIDDLE BASS TREBLE

LEVEL of DRIVE EFFECT - 0~1 position : bypass - 2~10 position : drive level * for GT channel only DUAL PREAMP CONTROL - 12 o’clock : minimum gain - turn to clockwise : heavy drive - turn to counterclockwise : tweed drive Reverb time and level control * for MIC and GT channel TWO WAY FOOT SWITCH - tip : drive on/off - ring : reverb on/off * drive and reverb controls must be set to desired sound DC POWER INLET * DC15V2A regulated or SMPS only CD / MP3 INPUT RCA-JACK POWER SWITCH POWER INDICATOR MASTER VOLUME INPUT GAIN CONTROL 3 BAND EQUALIZER GT channe l INPUT - for high impedance passive instruments MIC channel BALANCED XLR INPUT (for MIC or ACOUSTIC GUITAR) MIC channel BALANCED INPUT REC OUT / PHONE JACK 8 inch speaker 1 inch tweeter Bass reflex hole Battery Holder use ten AA size alkaline or rechargeable DIMENSION : L560 x D230 x H270 (mm) WEIGHT : 8.9KG (without Battery & P.S.) SPEAKER : 2 x 8 inch LF OUTPUT : 50 watts music power DC POWER : Max 2A @ 15V FREQUENCY RANGE : 60Hz ~ 8kHz BATTERY LIFETIME : avg 5~6 hours (Alkaline) EQ (Both ch) Bass frequency : 180Hz peak Bass gain : -10dB ~ +10dB Middle frequency : 900Hz Middle gain : -10dB ~ +10dB Treble frequency : 2KHz pak Treble gain : -10dB ~ +10dB MIC CH LOW-Z BALANCE XLR Max input level : +10dBV Max gain : 60dB LOW-Z (10kohm) BAL / UNBAL INPUT Max input level : +10dBV Max gain : 60dB GT CH HI-Z (500kohm) UNBALANCE INPUT Max input level : +8dBV Max gain : 70dB (for passive instrument) TWEETER ATTENUATOR SWITCH 8 inch speaker Power Adaptor (included)