Cooper 9448 Operation & User’s Manual
Text of the manual
AND / ET
9448+ and 9448ES Hard Wired Control Panel User Guide.
© Scantronic Ltd. 2001
Every effort has been made to ensure that the contents of this book are correct, errors and omissions excepted.
However, neither the authors nor Scantronic accept any liability for loss or damage caused or alleged to be
caused directly or indirectly by this book. The co
TO FULL SET
Key-in your four digit user code (shown as ???? at
left). The exit tone starts. Leave premises via the
designated exit door. Exit tone stops after a preset
time and the D light goes dark. Your alarm system is
SET.
TO PART SET
Your alarm system may have been installed to allow
you to have part of the premises set while other
area(s) a
TO OMIT A DETECTOR
You may need to temporarily set the system with
one or more detectors omitted. Key in the zone
number followed by OMIT for all the zones you want
to omit and then key in your user code. The system
flashes the light(s) of the omitted zone(s) during the
exit time and then sets. Note that you cannot omit a
panic or fire zone, or t
If the Panic light (zone 6) glows then deal with the
cause of the alarm first. Next, reset the panic button,
then switch the alarm system bells off and reset the
system (see above).
TO TEST BELLS
Make sure system is unset before starting the test.
Key in 4 then ENTER followed by your user code.
The internal sounders will operate for three seconds
