Crux Sightline VIMFD-95 Manual 

Using the RIGHT HAND SIDE SWC buttons you can activate and deac- tivate the video in-motion function. (ONLY WITH DIP SWITCH 1 OFF) Simply press and hold the LEFT arrow on the side mirror control. TO FACTORY HARNESS 8-PIN (male plug) WHITE/ OPTIONAL 12V OUTPUT 54-PIN (female plug) 54-PIN (male plug) 8-PIN (male plug) TO FACTORY RADIO 4 5 6 ON 1 2 3 4 5 6 ON 1 2 3 ------------------ ------------------ ------------------ GREEN/ 12V POWER SWITCH (SAME FUNCTION AS DIP 1) NON-PERMANENT FUSE (NOT INCLUDED) 12V OPTIONAL/ TOGGLE SWITCH NOT INCLUDED WHITE/ OPTIONAL 12V OUTPUT C-500 INTERFACE C-125 INTERFACE SAFETY WARNING: THIS INTERFACE IS DESIGNED TO ACTIVATE VIDEO IN-MOTION TO ALLOW THE PASSENGER ACCESS TO THE ADDRESS INPUT WHILE THE VEHICLE IS IN-MOTION. THIS INTERFACE MAY CAUSE AN ERROR WHEN SERVICED AT THE OEM DEALER. BE AWARE THAT MOST DEALERS WILL ATTEMPT TO VOID THE MANUFACTURERS WARRANTY WHEN INSTALLING ANY AFTERMAR- KET EQUIPMENT. IMPROPER USE OF THIS INTER- FACE BY THE DRIVER MAY RESULT IN CITATION. DRIVER MUST KEEP FULL ATTENTION ON THE ROAD AND RESPONSIBILITY ON THE SAFETY OF THEIR PASSENGERS. INTERFACING SOLUTIONS VIDEO IN-MOTION ACTIVATION FOR SELECT FORD MyFord Touch RADIOS 2011-UP FORD: 2011 - 2014 Ford Edge 2011 - 2014 Ford Explorer 2012 - 2014 Ford Focus 2013 - 2014 Ford Focus ST 2013 - 2014 Ford Taurus 2013 - 2014 Ford Escape 2013 - 2014 Ford F150 2013 - 2014 F150 Raptor 2013 - 2014 F250, 350, 450, 550 2013 - 2014 Ford Fusion Hybrid 2013 - 2013 Ford Fusion Energy 2013 - 2014 Ford Taurus 2013 - 2014 C-Max Hybrid 2013 - 2014 C-Max Energy LINCOLN 2011 - 2012 MKX 2013 - 2014 MKS 2012 - 2014 MKT 2013 - 2014 MKZ WORKS FOR ALL: MyFord Touch Radios NOTE: The radio system will go through a reboot process that may take up to 1 minute. It will initialize and re-load all previous settings. Once complete it will resume the original radio display. VIMFD-95 We recommend reading this installation guide first before starting any work. Following these instructions from “Start” to” Finish” will ensure a smooth and hassle free installation. We offer telephone support M-F 9:00 AM – 5:00PM PDT at 1 (855) 822-1348. We are here to help. PARTS INCLUDED: (1) FD-95 C-500 Interface (1) FD-95 C-125 Interfaces (1) FD-95 T-Harness (1) Instruction PRECAUTIONS: - Remove the negative side of the battery to avoid any short circuits durring the installation. - Do not install the interface near any major components or near the HVAC system. This may cause damage or overheating to the vehicle. - Do not disconnect the airbag connection behind the radio panel. PRELIMINARY: Please read the entire manual before installing this interface. This interface does not activate DVD reader. INSTALLING THE INTERFACE: 1. Remove the factory display to gain access to the factory connectors. 2. Remove the 54-Pin connector from behind the display. 3. Make the T-Harness connections behind the factory display. (if the connectors do not match please contact tech support) 4. Connect both Interfaces to an 8-Pin connector. No orientation. 4. Set the dip switches as needed on both interfaces. (See below) 5. Test the Navigation address input while the car is in-motion to verify the VIM is active. As an option we have provided a 12v output wire from our inter- face, as the vehicle does not provide 12v Acc 250ma. Do not use if not needed. INSTALLATION OVERVIEW Rev. 111113 TROUBLE SHOOTING 1. No video display while in-motion. - Make sure the dip switches are in the correct position. For more support contact tech support. CONNECT BEHIND THE DISPLAY (Not The Radio) ENABLE OR DISABLE (Video In-Motion) HOLD FOR 3 SECONDS AND RELEASE SETTING THE DIP SWITCHES Dip 1: Activates the Video In-Motion feature. The dip switch is the permanent solution for keeping the VIM unlocked. The SWC feature will be deactivated with this ON. Dip 5 & 6: These dip switches may vary. See attached slip sheet. FOR DIP SWITCH SETTINGS SEE ATTACHED SLIP SHEET

FORD: 2011 - 2014 Ford Edge 2011 - 2014 Ford Explorer 2012 - 2014 Ford Focus 2013 - 2014 Ford Focus ST 2013 - 2014 Ford Taurus 2013 - 2014 Ford Escape 2013 - 2014 Ford F150 2013 - 2014 F150 Raptor 2013 - 2014 F250, 350, 450, 550 2013 - 2014 Ford Fusion Hybrid 2013 - 2013 Ford Fusion Energy 2013 - 2014 Ford Taurus 2013 - 2014 C-Max Hybrid 2013 - 2014 C-Max Energy LINCOLN 2011 - 2012 MKX 2013 - 2014 MKS 2012 - 2014 MKT 2013 - 2014 MKZ WORKS FOR ALL: MyFord Touch Radios NOTE: The radio system will go through a reboot process that may take up to 1 minute. It will initialize and re-load all previous settings. Once complete it will resume the original radio display. VIMFD-95 Rev. 111113 COMPATIBLE RADIO: PIN 1/ VIM CONTROL CONFIGURATION DIP# C-125 C-500 RESULT Dip 1 OFF OFF Dip 2 ON ON User control of the VIM feature will be turned ON and OFF from the SWC. See instruction for SWC activation. VIM Permanently on. No control on SWC PIN 5 & 6 VIM CAN CONFIGURATION ATTEMPT 1 ATTEMPT 2 ATTEMPT 3 ATTEMPT 4 In the case where the VIM does not function or the radio may not turn on, this may be due to incorrect combination of Pin Configuration. Dip 5 Dip 6 Dip 5 Dip 6 Dip 5 Dip 6 Dip 5 Dip 6 C-125 C-500 OFF OFF OFF OFF OFF ON OFF ON ON ON OFF ON ON ON OFF ON INTERFACING SOLUTIONS DIP SWITCHES SLIP SHEET PIN 1/ VIM CONTROL CONFIGURATION DIP# C-125 C-500 RESULT Dip 1 OFF OFF Dip 2 ON ON User control of the VIM feature will be turned ON and OFF from the SWC. See instruction for SWC activation. VIM Permanently on. No control on SWC PIN 5 & 6 VIM CAN CONFIGURATION ATTEMPT 1 ATTEMPT 2 ATTEMPT 3 ATTEMPT 4 In the case where the VIM does not function or the radio may not turn on, this may be due to incorrect combination of Pin Configuration. Dip 5 Dip 6 Dip 5 Dip 6 Dip 5 Dip 6 Dip 5 Dip 6 C-125 C-500 OFF OFF OFF OFF OFF ON OFF ON ON ON OFF ON ON ON OFF ON INTERFACING SOLUTIONS DIP SWITCHES SLIP SHEET