Craden DP8 Installation Manual

2. Press the cabinet latches on the lower front cabinet sides and rotate the cabinet upwards. 3. Remove the foam blocks on each side of the carriage. 4. Install the ribbon cartridge (See 3.1) 5. Connect the interface cable. (See 3.11.3 for cabling information). 6. Check that the power switch on the printer rear is off (“0” side depressed). Connect the line cord between the printer and an electrical outlet. The printer accepts 110 to 240VAC nominal input. If a line cord was not supplied with the printer procure an IEC HAR line cord that has an IEC 320-C13 style connector and the appropriate HAR plug for your country. 7. Turn on the power switch. READY should appear on the display. If the display is not legible adjust the contrast knob located on top of the mechanism beneath the cabinet. 8. Configure printer and interface parameters (See 3.5-3.5.2) using 92 and 93 FUNCT. Common variations to the default settings are a higher baud rate for better throughput, EMULATION MODE I for Proprinter emulation and PROTOCOL = XON/XOF for software that does not use DTR hardware handshaking. Function 94 settings are factory set for a specific printer and should not be changed. 9. Perform a local print test (See 3.8) with 95 FUNCT. 10. If host printing is incorrect, check that 93 FUNCT Communication Parameters match the host parameters and review all 92 FUNCT Printer Parameters. Push in on cabinet latches Rotate cabinet up and back. 1 Rotate lift ring forward to lift and lock carriage. 3 Push ribbon guide plate tabs down. 4 Rotate cartridge into place and snap in. Rotate cartridge drive gear clockwise to align and take up ribbon slack. Push shield up. Lower carriage into operating position. Close cabinet. 6 2 Remove foam shipping blocks. 5 RUBBER WHEEL RIBBON SHIELD TABS RIBBON PATH Slip ribbon over and behind guide plate tabs. 1 2

is not used, insure that printer and the printer carriage will not move during shipment and that the unit has sufficient protective padding. Ribbon guide & shield DP9 printer with cabinet open, lift ring down and ribbon guide down Lift Ring Ribbon Cartridge Printhead DP9 Ribbon Fit, Sides Tabs DP8 Ribbon Fit, Sides Tabs Cartridge Clip