Craftsman mower with rear roller Assembly Instructions
Read Online
Read the Craftsman mower with rear roller Assembly Instructions online using the built-in PDF viewer.
Text of the manual
_ _Step 1: Snap wire loop #1 over or into #2 and crimp closed with pliers; repeat
for opposite side.
Step 2: Push wire support foot through loop sewn into bottom of pan. This
wilt support top rail.
Step 3: Snap two front rod covers over wire #1 to complete assembly of
catcher.
You are now ready to attach catcher to your lawn
mower. There are 3 different variations. The
correct one for you depends on the style and type
of your mower.
Attachment
Option
'%"
for mower
with
rear
roller
assembly
I: for
14" and
16" mowing
width
II: l[br 18" mowing
width
I. Refer
to
Step
1:
Step
2:
Step
3:
Step 4:
Step 8:
Step 6:
figure #1 for 14" and 16" mowers.
Using a socket or box end wrench, remove the hex nut o1"wing nut
holding the roller bracket onto the mower.
Place the catcher hook over the bolt and against the side plate as
shown.
Replace the nut onto the bolt and retighten the nut, being careful to
keep the catcher hook as straight as possible. (It may be necessary
to adjust this alignment after both sides are in place.
Repeat for opposite side.
The wire at the front of the catcher is placed into the slots of the
catcher hook. Since a reel tba'ows grass to the left, a placement on
center or slightly left of center is recommended.
[Fig, 2]
Attach hook at rear of catcher to handle, adjust for your height and
technique.
lI.
Refer
to
Step
1:
Step
2:
Step 3:
Step 4:
Step 5:
Step
6:
figure
#3 for installation
on 18" mowers
with
rear
rollers.
Remove
wing nuts holding
roller
bracket
to 18" mower.
While
holding
the bracket
in place,
remove
bolt
and slide
bolt into
slot of catcher
hook.
Replace
bolt into desired
hole of bracket
and
side plate. (Be sure brackets
are placed
so that they move
attachment,
slot toward
center
of mower.
Replace
and retighten
wing
nut, adjusting
catcher
hook as you go
to be as straight
as possible.
Repeat
for second
Side.
The catcher
wilt fit between
the mower's
side plates
The wire
should
be placed
into slot on catcher
hook
as shown.
(It may be
necessary
to angle
the hooks
slightly
upwards.)
[Fig. 4]
Attach
hook
at rear of catcher
over handle;
adjust
for your height
and technique.
FIG.
1
14" and
16" mowers
FIG.
3
18" mowers
Z
FIG. 4
Refer to figure #5
Step 1: The catcher has a formed section at the
front underside. Snap this over the
support tube and into place.
Step 2: Attach hook at rear of catcher over
handle and you're ready to go. You can
adjust the location of the hook to your
mowing technique.
Note: The catcher
,-_
Catcher
