Bastl Instruments MULTIPLE Assembly Manual
Text of the manual
last update: 8. 3. 2016
MULTIPLE Assembly Guide
bastlinstruments.com
INTRODUCTION
This guide is for Multiple from Bastl Instruments. This is a beginner level kit. If you have never soldered
before, check out this tutorial first . We even included some of the best quality solder to help you solder
1
everything faster and better.
1 http://www.instructables.com/id/Howtosolder/
The Multiple consists of only few components. See Bill of Materials (BOM) for detailed list.
Before starting this kit, prepare the following tools :
●
Soldering iron (1520W)
●
Flush cutters
●
Phillips screwdriver (cross)
●
Wrench No. 8
●
Protective eyewear
We suggest that you work in a clean and a well lit and ventilated environment to avoid accidents or
losing any of the small components.
SOLDERING AND ASSEMBLY
Place all nine jack connectors into front panel (watch out for the orientation!) and secure them with
nuts and washers.
Tighten the jack nuts (you do not have to tighten
them too much as you may damage the wooden
panel).
Prepare the wires. Put the isolation off. If they are bent, straighten them. Push one of the wires through
the openings in the middle of jack legs and solder it.
Solder the other wires with side legs on jacks. You might start with just one leg soldered. Wait for it to
cool and do the rest.
Cut off the overhanging wire.
Bend the legs slightly inwards to fit the module into your system.
Congratulations! You have made it through. At this moment you can choose by cutting the wire how do
you want to split the signal (see the manual). Then you can add the Multiple to your system. There is no
power connection needed since the multiple is a passive module.
