Basalte ASANO BO.sensor 770-01 Installation Manual

KNX systems and allows controlling KNX lights, screens and scenes with the Beo 4 and Beo 6 remotes. BO.sensor supports all AV controls like TV, RADIO and DVD, allowing you to control the complete Asano system. The BO.sensor module sits behind the original Bang & Olufsen infrared sensor powering it directly from the KNX bus without any additional power supply (Bang & Olufsen infrared sensor not included). Components A KNX connector B Programming button C Programming led D Beolink connector E Connector pins B A C D E Compatible devices The BO.sensor is compatible with the following Bang & Olufsen infrared sensors:  Ref. n° 8089110 IR kit These sensors can be installed in two types of wall boxes:  3375187 (solid walls)  3375188 (dry walls) Model No. 770-01 Safety instructions Before operating the unit, please read this manual thoroughly and retain it for future reference. Failure to observe these instructions might damage the device The device may only be installed and connected by professional electricians IMPORTANT ADVICE  Never connect the device to 230V or in the vicinity of. Make sure to maintain the distance to them specified in the applicable standards and regulations.

 Place the connector pins (E) of the BO.sensor into the 5 port connector of the infrared sensor and screw them tightly  Connect the bus line according to the KNX standard.  Load the physical address into the BO.sensor from ETS via the KNX bus.  Commission the BO.sensor in ETS and load the configuration into the device Technical Data Ambient temperature: Operation: -5°C to 45°C Storage: -15°C to 55°C Transport: -15°C to 55°C Dimensions: diameter 62.5mm Height 22mm Weight: 0.02 kg Max. humidity: 93% relative humidity, no moisture condensation Protection class: IP20 Certification: CE