CANchecked MFD28 Quick Start Manual

- Precrimped cables - Four fastening screws - MicroSD card (installed) - MicroSD adapter to SD - Diffuse display foil - 2x 1K1 pullup resistor (for NTC) - additional pins for own crimps More information More information on the display and other products and accessories you can find online at: www.canchecked.de www.canchecked.de/mfd28/ Plug A: Molex 43025-0800 Plug B: Molex 43025-1000 Crimp: 43020-0001 PLUG A A1 A2 A3 A4 A5 A6 A7 A8 * future GND 5V AIN4 AIN3 12V GND AIN2 AIN1 Application PLUG B B1 B2 B3 B4 B5 B6 B7 B8 B9 B10 RX2* CANH CANL SHIFT RX TX2* * 5V GND TX

cable needs to be fused with 5A. Connect ground to A1 and 12V to A5. The measurements for the mounting hole and the screw holes can be found in the upper drawing. In addition, only the can bus cables (high/low) needs to be connected. Implementation After the start-up, the splash screen appears and after 5 seconds or tap on the screen you will get forwarded to the first view. The ten predefined views give you a rough guidance of what is possible to display. By a tap on the screen, you can stop the display and you will see the following view: Touch areas on the screen 1) Setup current widgets 2) Menu for setup 3) View back (current view -1) 4) View forward (current view +1) 5) Backlight adjustment 6) Back to dataview Optional accessories: 1) Shift light 2) Haldex control 3) Serial adapter for some special ECUs (e.g. VEMS) 4) Car specific bezels (replace the four fastening screws) On questions regarding accessories or functionality please get in contact with us via our homepage (www.canchecked.de) or via email ([email protected]). 1 2 1 6 3 4 5