Lockly LATCH EDITION SECURE PGD628 Installation Manual

version of this installation guide. Download the BILT app in the Apple or Google Play store for step-by-step interactive 3-D walk-through installation instructions. OR OR ...

Step 5 Interior Positioning rods slide through these holes. Install the side with the black plastic seal against the door. Insert Positioning Rods V into the holes to the left and right of the Spindle C . The holes are located at the 3 o’clock and 9 o’clock positions. Interior Mounting Plate LK will go against the interior side of your door. Remove the paper layer off of the Adhesive Tape and align the positioning rods on the bottom of the plate to the corresponding left and right holes. V Mounting Plate LK 1 2 ...

may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate ...

version of this installation guide. Download the BILT app in the Apple or Google Play store for step-by-step interactive 3-D walk-through installation instructions. OR OR ...

Step 4 Exterior Install the exterior lock as shown to the left by aligning the lock straight and passing the cable and attached rods through the lockset. Align the lock straight and press hard (if you use the Adhesive tape in step 3.4) to secure the top of the lock. Pass the Spindle C through the center of the lockset, and the round rods through the sides in their respective holes. The cable should run underneath the lockset. 1 2 3 ...

Step 6 （2X） DOOR STRIKE INSTALLATION Close your door to see if your lock closes securely with your existing door strike. If the lock closes securely, you may keep the existing door strike without removing the old hardware. However, it’s recommended that you use our door strike. F H G Make sure the slanted side of Latchbolt ( F1 / F2 ) is closing against the slanted part of Strike Plate H before fixing it on to door frame. ...

Welcome! This guide will walk you through step-by-step how to install and get your LOCKLY® Secure up and running. Installation generally takes less than 30 minutes. If you have any questions please reference our online support at: LOCKLY.com/support or call (669) 500-8835 for help. ...