LONEALERT Man Down X Instruction Manual

Initial man Down X setup LONEALERT User Guides GPS LED Flashlight (Green) A call is coming in or busy Sleeping No GPS fix or initialising GPS Fix Low battery Speaker GPS Indicator Answer/end call button SOS button Lanyard Hole Volume up GSM Indicator Microphone Volume down Power button Micro USB port Battery cover Flashing (every 5 seconds) Flash (1 second on, 1 second off) GPS LED Flashlight (Blue) Continuous light Charging Continuous light Off Fast flash (0.3 sec on, 0.3 sec off) Off Connected to GSM network No GSM signal or initialising Sleeping Flashing (every 5 seconds) Flash (1 second on, 1 second off) Step 7) Replacing the battery cover Place the battery cover back onto the Man Down X and use the mini screwdriver to screw it in place. Take care not to cross-thread the screws. Step 8) Check the Man Down X Now that you are ready to check that your Man Down X has been set up correctly, follow the instructions on the next page. LED Indications Step 2) Removing the battery Lift the battery from the notch at the bottom and pull it out of the Man Down X towards you. Step 3) Opening the sim card slot With the Man Down X lay flat in front of you, there will be 2 silver components, the one on the left is for the sim card, to open it, slide the silver component down towards you and fold it up towards you. Step 1) Removing the battery cover With the Man Down X turned off, place your Man Down X with the front facing down. Use the mini screwdriver (included) to remove the two screws to release the back cover. Lift the back cover from the notch at the bottom of the Man Down X. Step 4) Inserting the sim card Pop out the micro sim card found within the box and place it into the Man Down X, (gold side facing down) making sure the notch in the corner matches with the sim card holder. Step 5) Closing the sim card slot Fold the silver cover down onto the sim and slide it up away from you to lock the sim in place. Step 6) Replacing the battery Place the battery back in the Man Down X with the gold tab matching with the connectors in the top left of the Man Down X. To download digital versions of our user guides, either scan the QR code above, or head to: https:// www.lonealert.co.uk/lonealert-user-guides/ www.LONEALERT.co.uk +44 (0)330 999 8484 360-0000 Document Reference: 367-2001 - Man Down X complete guide Please note: GPS location can take a few minutes to find you when you power your Man Down X up for the very first time. We suggest that before use, you place it close to an external window or wear it outside for around 30 minutes.

Finding this guide difficult to read? You can download a digital version at: https://www.lonealert.co.uk/lonealert-user-guides Power On Press and hold the power button located on the side of the Man Down X until it beeps and you see the 2 LED lights turn on. Power Off Press and hold the power button until the LED lights go off, then press and hold the power button again for approx. 3-4 seconds and let go - you should notice the Man Down X beeps twice to alert you that it has powered off successfully. 2) Timers Set a timer Press and hold the + button on the side of the Man Down X until the device vibrates. Cancel a timer Press and hold the – button on the side of the Man Down X until the device vibrates. Update a timer First you must cancel your timer, then you can set a new timer using the + button. Set a custom length timer Press and hold the phone button on the front of the Man Down X until it vibrates and beeps. This will ring through to our check call service, at which point you will have the following options: If you fail to update your timer and it elapses, you will receive a call to your Man Down X or to your phone number registered with LONEALERT. This is to notify you that your timer has expired and requires updating to let people know that you are OK. If the call comes through to your mobile phone, you can enter your pin code as prompted using your phone’s dial pad - your timer will be restarted if you had a periodic timer set, or cancelled if you set a standard timer. If the call comes to your Man Down X you must end the call by pressing the phone button, then set a new timer using the + button or cancel your timer using the – button. 4) End call If you are currently on a call (e.g. custom timer function), you can press the phone button to end the call. 5) Raise Panic To raise a panic alarm, press and hold the SOS button on the front of the Man Down X for approx. 2-3 seconds. The Man Down X will beep and vibrate to let you know it has been pressed, then raise a panic in accordance with your company procedure. If you have our LONEALERT ARC set as your first point of contact, your Man Down X will raise a 2 way call with them. If this disconnects, the ARC can call you back. If your Man Down X is set up to follow your company's internal procedure, the relevant contacts will receive an automated message, alerting them that you have raised a panic. This allows them to action the alert and try to get in contact with you. 6) Man Down If the Man Down X is tilted over approx. 45 degrees for 10 seconds, it will begin beeping at the wearer. To stop this, simply tilt the Man Down X back upright and after a few seconds it should stop beeping and return to its normal working mode. If the Man Down X is not put upright, it will continue to beep for 2 minutes. If this elapses, it will then trigger a man down alert in accordance with your company’s escalation procedure, going to our ARC or to your company’s internal escalation. Man Down X - Charging 3) Pin code request Blue LED fast flashes (0.3 seconds on, 0.3 seconds off) Low Battery Start function to set a default length timer which is described in the O.W.L Platform. Custom function to create custom timers. Cancel function to cancel currently set timers. Select an option by speaking into the Man Down X when prompted, and you will then be instructed by the automated voice on how to proceed. Note: While the Man Down X is charging and the power is on, the Man Down feature will be active - to avoid false alarms, we recommend that you switch your Man Down X off and it will continue to charge. If a switched off Man Down X is placed on charge, it will power the Man Down X on - however, it can then be turned off while it continues to charge. Blue LED is solid when plugged in Charging To reach full power, we recommend that you leave your Man Down X charging for 3-4 hours.