METHVEN EDGE RAIL Installation Manual

under the general operating conditions specified in this instruction sheet. However, regional regulations apply and may affect your warranty. Please refer to www.methven.com or call customer service for full details. New Zealand 0800 804 222 Australia 1300 638 483 UK 0800 195 1602 TECHNICAL SPECIFICATIONS: Inlet Connections: All ½" BSP Clean filter washer periodically CARE AND CLEANING: Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with contamination free warm soapy water and a damp soft cloth. 439970 ISSUE B EDGE RAIL

instructions before installation. GENERAL: This product must be installed in compliance with all relevant regional regulations. It is the responsibility of the installer to ensure a waterproof seal is achieved between the product and mounting surface. If in doubt about the quality of the seal, remove the product and reinstall using silicone to ensure a seal is achieved. All pipe work must be thoroughly flushed prior to the installation of the Hose and Handset (if supplied). After installation all connections must be checked for leaks. All outlets used primarily for personal hygiene shall deliver water at a safe temperature as per regional regulations. • • • • Wall Boss Housing Grub Srew Rail Slider Internal Mounting Bracket and Screw Wall Boss Screws grub screw topside grub screw underside Secure the wall boss housings. NOTE: Ensure protection pads are used between wall bosses and tiles. FLOOR 1000mm RAIL 810-945mm 800mm RAIL 570-745mm 1850mm (recommended) VERTICAL 700mm RAIL 510-645mm Fitted Endcap IF SOAP DISH IS SUPPLIED: Slide soap dish onto the rail from the end with the endcap already fitted. Fit the internal mounting brackets by locating in slot rotating 90° as shown. Tighten the screws finger-tight using Allen key provided. 1. 2. Match the mountings to wall bosses and push into place Slide the rail up or down to centralise brackets. 1. 2. Remove the rail and tighten the tensioning screws until they lock. Relocate the rail onto wall bosses and tighten grub screws top and bottom. 1. 2. Fit end cap to top of rail. Ensure drainage hole is at back. To adjust slider friction rotate side piece anti-clockwise to loosen and clockwise to tighten. IF HANDSET, HOSE OR WATER OUTLET ARE SUPPLIED: Connect hose to water outlet and Methven handset. Ensure swivelling cone is connected to the handset. Non-Swivelling Cone Filter Washer Flat Washer Handset (If supplied) Swivelling Cone 1. 3. 2. 4. 5. 6. 8. 7. Water Outlet (If supplied) Soap Dish (If supplied) Water Outlet (If supplied)