METHVEN DEVA ETHOS ETH106 Installation Manual

METHVEN EXPERIENCE CENTRE 3/3A STONE CROSS COURT YEW TREE WAY GOLBORNE WARRINGTON WA3 3JD UNITED KINGDOM Warranty Information Proof of purchase will be required. The guarantee does not cover faults or damage caused by incorrect installation and/or maintenance, ordinary wear and tear, water composition, etc. *Please see www.deva.org.uk for full terms and conditions of warranty Cleaning Your product has a high-quality finish and should be treated with care to preserve the visible surfaces. Never use abrasives or abrasive cleaning agents to clean this product clean regularly with contamination free warm water and a damp soft cloth. Do not use products containing chlorine bleach or hydrochloric acid as these can damage the product. ETHOS BATH SHOWER MIXER Installation Guide Operating Pressure Min: Max: Operating Temperature Hot: Cold: 0.5 Bar 5.0 Bar 65⁰C 5⁰C Inlet Connections 3/4” BSP INST-ETH106-V1 TEL: 0800 195 1602 FAX: 0844 406 8690 EMAIL: [email protected] www.methven.com We have a policy of continuous improvement and reserve the right to change specifications without notice.

General Installation Instructions Methven recommends this product is installed by a competent person in compliance with all relevant regional regulations. After installation all connenctions must be checked for leaks. All outlets used primarily for personal hygiene shall deliver water at a safe temperature as per regional regulations. It is the responsibility of the installer to ensure a waterproof seal is achieved. 1) Remove the back nuts and back nut washer from the threaded tails. 2) Push the mixer tails through the holes in the bath, ensuring that the base rings and base ring washers are correctly positioned, fully covering the mounting holes. 3) Place the back nut washer and back nuts back onto the tails, under the bath, and screw up until the tap is secured in position (do not overtighten). Please note additional sealant can be used if required. 4) Connect the water supply pipes to the tails and tighten, an adequate sealing method should be used to create a watertight seal. 5) Identify a suitable location for the wall bracket, so that the hose will not be under tension when fitted. Attach to the wall using either the plugs and screws supplied or other suitable fittings for the specific installation. 6) Fit a hose washer into each end of the hose, connect the handset to the cone shaped end and the other end to the hose outlet on the mixer. 7) Reinstate the water supply and test for leaks.