KwikGoal 7A601 Assembly Instructions
Read Online
Read the KwikGoal 7A601 Assembly Instructions online using the built-in PDF viewer.
Text of the manual
NZ417 Rev. 03/22/17
140 Pacific Drive Quakertown, PA 18951
(P) 215-536-2200 / (P) 800-531-4252 / (F) 215-536-4309 / (F) 800-778-8869
Visit our website @ kwikgoal.com
2017 Kwik Goal Ltd.
Parts
ASSEMBLY INSTRUCTIONS FOR 7A601 KWIK FLEX BACKSTOP
1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred,
notify trucking company immediately.
Net (1)
(Part# VZ801)
Left Base
(Part# VZ796)
Rail w/ Connector (2)
(Part# VZ795)
Center Connector (1)
(Part# VZ794)
Carry Bag (1)
(Part# VZ791)
Middle Rail (2)
(Part# VZ798)
Angled Rail (2)
(Part# VZ797)
Right Base
(Part# VZ800)
Tension Rod w/ Net Attachment (2)
(Part# VZ793)
46-7/8”
Tension Rod w/ Coupler (4)
(Part# VZ792)
48-3/8”
Ground Anchor (4)
(Part# 10B1201 Pack of 4)
Right Base
(Part# VZ800)
Left Base
(Part# VZ796)
NZ417 Rev. 03/22/17
2. Open frame by swinging outward. Use care to keep net from getting pinched in moving parts.
3. Extend rail sections by pulling on each base connector until buttons lock into place. Do not force parts.
Parts should move freely, if parts do not, look for points where net may be caught on frame.
Pull
Pull
Pull until button locks in place
(4 places along rail)
Frame
Frame
Center Connector
Base Connector
NZ417 Rev. 03/22/17
4. Open one side of the bases by swinging outward until buttons lock in place. Pull elastic bands and place loop
over metal hook on each side.
Net Sleeve
Net Sleeve
5. Add one tension rod w/coupler to each base through net sleeve on sides of net.
Tension Rod w/ Coupler
Tension Rod w/ Coupler
Open until button is engaged
Base
Attach band to hook
Feed tension rods
through net sleeve
on each side
Coupler
NZ417 Rev. 03/22/17
6. Tilt frame towards the unopen bases to add remaining tension rods. Attach net attachment loops to net
attachment points on poles.
7. Stand unit upright and open opposite side bases by
swinging outward until button locks into place.
Tension Rod w/ Coupler
Tension Rod w/ Net Attachment
8. Install ground anchor at each corner. Use rubber mallet to hammer anchors into ground.
NZ417 Rev. 03/22/17
Go to kwikgoal.com for additional product information.
Anchor Tether
Anchor
Anchor Detail
(4 Places)
