Maxx MIM-50 Service Manual

As the icemaker is properly installed. switch on the water tap, let the water trough full (reach on the level), then turn the ICE/OFF/WASH switch to the ICE position on the front panel. The icemaker will start working automatically In this status, the time is fixed about 3 minutes. This function is also helpful to protect the compressor avoiding restart within 3 minutes. At this status, the Red, Green, Yellow LEDs are light together. 2. Ice-making Status The compressor, motor fan and pump are powered on. The hot gas solenoid valve is p ...

As the icemaker is properly installed. switch on the water tap, let the water trough full (reach on the level), then turn the ICE/OFF/WASH switch to the ICE position on the front panel. The icemaker will start working automatically In this status, the time is fixed about 3 minutes. This function is also helpful to protect the compressor avoiding restart within 3 minutes. At this status, the Red, Green, Yellow LEDs are light together. 2. Ice-making Status The compressor, motor fan and pump are powered on. The hot gas solenoid valve is p ...

high. Adjust the ambient temperature. Electronic controller The setting temperature is high. See the service manual "adjust the size of ice cubes" Refrigerant Refrigerant leaks Recharge. Cubes are too big Electronic controller The setting temperature of Electronic controller is low. See the service manual "adjust the size of ice cubes" Sensor Temperature sensor of the evaporator damages Replace the sensor of temperature. The ambient and water temperature The ambient temperature and water temperature is too low. Adju ...

10 Discharge tube 19 Wiring harness 39 Controllerbox 39.1 Temperature sensor of the condenser 39.2 Temperature sensor of the evaporator 46 Evaporator (Ice Mold) During the ice-making stage, the hot gas solenoid valve is closed. The hot refrigerant gas is pumped out off compressor to condenser. The hot gas is cooled by fan forced air to warm liquid refrigerant after passing through the condenser. The drier & filter reduces the possible dirty and humidity in the refrigerant. The evaporator is cooled by the refrigerant. So ice can formed on the evaporator during water is ...

of the compressor Drainage tray on top of the compressor is full Drain off water by unscrewing lower drainage nut. Problem kinds Check part or point Possible Cause Probable Correction The compresso r doesn't start or start frequency Wiring connects loose. Plug tightly, or replace. The start relay/ther mal protect Be damaged. Replace the start relay/thermal protect of the compressor The startup coil / running coil Be turnoff. Replace the compressor. The motor of the compressor is short circuit. Replace the compressor. Condenser The condenser may be dirty. Clean the conde ...

Replace Controller, fuse and the sensor of temperature  Remove the rear cover, front panel,  Locate the Electronic controller,  Pull out the sensors of temperature (one at the evaporator, another at the condenser).  loosen the screws of rooting the Electronic controller, replace a new one. Reverse the above step to replace.  If you need replace the fuse, open the front panel of the control box, you will find the figure. According the figure, take out the fuse, replace a new one. Reverse the above step to reassemble.  If you need replace the senso ...

10 Discharge tube 19 Wiring harness 39 Controllerbox 39.1 Temperature sensor of the condenser 39.2 Temperature sensor of the evaporator 46 Evaporator (Ice Mold) During the ice-making stage, the hot gas solenoid valve is closed. The hot refrigerant gas is pumped out off compressor to condenser. The hot gas is cooled by fan forced air to warm liquid refrigerant after passing through the condenser. The drier & filter reduces the possible dirty and humidity in the refrigerant. The evaporator is cooled by the refrigerant. So ice can formed on the evaporator during water is ...