INSTEON 2441TH Owner's Manual

LCD display after 2 seconds. LCD display when using Up or Down arrows to select from the 4 controller groups. ...

1) Press and hold controller’s scene button until controller beeps.1 Controller’s LED will blink. 2) Press and hold controller’s scene button again until controller beeps again. Controller’s LED will continue blinking. 3) Press and hold Insteon Thermostat’s Set button. Insteon Thermostat Set LED will blink green and unit will beep. Insteon Thermostat will double-beep. LED will return to previous state. Controller’s LED will stop blinking. 3) Confirm scene remo ...

Beep Software configurable Yes RF range Up to 150-Feet (50m) open air Phase bridge detect beacon No, RF only device Insteon device category 0x05 (all frequencies) Insteon device subcategory 2441TH (915 MHz) 0x0B 2732-422 (869 MHz) 0x0F 2732-522 (921 MHz) 0x10 2732-242 (915 MHz) 0x13 2732-442 (869 MHz) 0x14 2732-542 (921 MHz) 0x15 X10 X10 address N/A X10 transmitter N/A X10 receiver N/A X10 status response N/A X10 resume dim N/A X10 minimum transmit level N/A X10 minimum r ...

Insteon Thermostat Operation and Programming Mode Button Operation Off Mode: • No setpoints are shown. • Up/Down arrows do not do anything. Heat Mode: • Only Heat setpoint is shown. • Up/Down arrows change Heat setpoint. Cool Mode: • Only Cool setpoint is shown. • Up/Down arrows change Cool setpoint. Auto Mode: • Both Cool and Heat setpoints are shown. • Up/Down arrows increase or decrease values by the same amount. Time of Day Mode: • The program mode is ...

Certification and Warranty FCC and Industry Canada Compliance Statement This device complies with FCC Rules Part 15 and Industry Canada RSS-210. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de ...

Wire Connections – Heat Pump Systems Wire color from Heat Pump unit Wire colors may vary Function Install on Insteon Thermostat connector Black or blue Common 24V 24V COM Red Power 24V 24 RH Orange or Brown Reversing Valve O/B White Auxiliary Heat AUX Green Fan G Yellow Compressor Stage 1 Y1 Blue Compressor Stage 2 Y2 Diagram below shows inside of Insteon Thermostat for Heat Pumps wall mount case: Adjusting the Reversing Valve Function This setting tells the heap pump w ...

Humidity Calibration Mode 1) Once in Setup Mode for temperature calibration (step 1 above), tap Mode button to step between temperature calibration and humidity calibration. 2) Press the Up or Down arrow to select the current humidity level. • The top left number (40 in example) is the current reading according to the humidity sensor. • The top right number (-92 in example) is the current offset (represents -9.2). • These numbers can change while this screen is disp ...