LeCroy 5U Assembly Instructions

11 1 T15 TORX L-KEY 10 10 #6-32 x .250" PAN HEAD SCREW 9 4 NYLON WASHER 8 4 #6-32 x .500" HEX STANDOFF 7 6 #6-32 x .375" FLAT HEAD SCREW 6 4 M5 x 12mm PAN HEAD SCREW 5 2 HANDLE 4 1 RACKMOUNT FRONT PLATE 3 1 RACKMOUNT RIGHT SIDE 2 1 RACKMOUNT LEFT SIDE 1 1 RACKMOUNT BASE

1. Assemble the handles (Item #5) to the front plate (Item # 4) using four pan head screws (Item #6). Note: Place handle on the side with the seven countersink holes. 2. Assemble the rackmount kit by mounting the base plate (Item #1) to the front plate (Item #4) using two #6 flat head screws (Item #7) and two #4 flat head screws (Item #12). 3. Attach the left and right side plates (Item #2 and 3) to the front plate (Item #4) using four flat head screws (Item #7). 4. Secure the left and right side plates (Item #2 and 3) to the base plate (Item #1) using six pan head screws (Item #10). 5. Place the four bumper (Item #13) onto the base plate (Item #1). Locate the bumpers approximately 1" inward from the center of the four large holes on the base plate. FIGURE 1

PUTTING THE SCOPE IN THE RACKMOUNT 1. Remove the four black screws from the scope’s left and right side surfaces with the Torx L-Key (Item #11) as shown in Figure 2. 2. Insert the nylon washer (Item #9) onto the hex standoff thread (Item #8) and screw the standoffs into the four mounting locations where the four black screws were removed as shown in Figure 3. 3. Place the scope on the rackmount base and align the standoffs to the side panel holes. Screw the four pan head screws (Item #10) into the standoffs (Item #8) to lock the scope into place as shown in Figure 3. ADDITIONAL INFORMATION Warning: The front panel of the rackmount assembly includes eight holes to secure the assembly to the rack. The front panel must be secured to the rack to prevent potential injury. Rackmount: The rackmount should only be used with a LeCroy WaveRunner 6000 Series Oscilloscope. LeCroy assumes no responsibility if the rackmount is used with another scope. Max DSO Dimensions (HxWxD): 8.5" x 13.8" x 14.4" (excluding feet) 216mm x 351mm x 366mm Rackmount Dimensions (HxWxD): 8.72" x 18.98" x 14.52", 221.5mm x 482.1mm x 368.8mm ORDERING INFORMATION WR6-RACK2 FIGURE 2 FIGURE 3 Copyright © March 2004 LeCroy is a registered trademark of LeCroy Corporation. All rights reserved. Information in this publication supersedes all earlier versions. Specifications subject to change without notice. 902253-00 Rev.A