LaserLiner MultiMeter-Compact Manual 

Referenzwert. Somit wird die Differenz zwischen dem aktuellen Messwert und dem gespeicherten Referenzwert im Display angezeigt. Drücken Sie in der jeweiligen Messfunktion während einer Referenzmessung die Taste „REL“. Im Display wird nun der Differenzwert zwischen der aktuellen Messung und dem gesetzten Referenzwert angezeigt. Erneutes Drücken der Taste „REL“ de- aktiviert diese Funktion. Die Rel-Funktion ist nur in den Bereichen Spannungs- und Strommessung, Durchgangsprüfung und Kapazi- tätsmessung möglich. V ...

the „Warranty and Additional Information“ booklet as well as the latest information under the internet link at the end of these instructions. Follow the instructions they contain. This document must be kept in a safe place and passed on together with the device. ! – The device must only be used in accordance with its intended purpose and within the scope of the specifications. – The measuring tools and accessories are not toys. Keep out of reach of children. – Modifications or changes to the device are not ...

source and then from the device. Remove all screws from the rear of the meter and then remove the battery. Open the housing and replace the fuse with one of the same type and specification (10 A /600 V). Close the housing and carefully screw the meter back together. Replacing the fuse The single-pole phase test is not suitable for checking for zero voltage. To do this, you need to carry out a two-pole phase test. ! For reasons of safety, you must disconnect the black measuring lead from th ...

the rotary switch to position „CAP“ and press the „Mode“ button three times to activate the „Capacitance measurement“ function. Then connect the measuring contacts to the object to be tested. In the case of poled capacitors, connect the positive pole to the red test prod. Capacitance measurement Forward direction Reverse direction Forward direction To test the diode, turn the rotary switch to position „Ω“ and press the „Mode“ button once to activate the „Diode test“ function. Then connect the measur ...

the rotary switch to position „V“ and press the „Mode“ button to set the voltage mode (AC, DC). Then connect the measuring contacts to the object to be tested. The measured value acquired and the polarity appear on the display. Voltage measurement DC/AC Do not measure currents above 10 A for longer than 30 seconds. This could damage the device or the test prods. ! Current measurement DC/AC To take a current measurement, turn the rotary switch to position „10 A“ and press the „Mode“ button to set the voltage mode (AC, ...

to position „Ω“ and press the „Mode“ switch twice to activate the „Continuity test“ function. Then connect the measuring contacts to the object to be tested. A measured value of < 150 ohms is recognised as continuity; this is confirmed by an audible signal. If „O.L.“ appears on the display instead of a measured value, either the measu- ring range has been exceeded or the measuring circuit is not closed or has been interrupted. Continuity test When measuring resistance, to avoid the risk of the results of a measuremen ...