Hipac 116597 Installation Manual

behind all our medical products, both manufactured and imported, because we’re here for the life of our products and clients. PO Box 797, 36 Long St. Goulburn NSW 2580, Australia P. +61 2 4823 0000 E. [email protected] SYDNEY | MELBOURNE | BRISBANE | ADELAIDE | PERTH hipac.com.au ABN 27 600 353 688 DDA Contour Grab Rail Installation Guide Hipac Product Codes: 116597, 116598, 116975, 116976, 116593, 116594, 116595, 116596 Hipac Pty Ltd can take no responsibility for incorrect fitting of Grabrails that are not fitted as directed in these instructions. 1. Correctly measure position of rail from floor and walls. If required rail can be installed at small fall to allow for easier cleaning and washing. 2. Position the rails and mark the position of the holes for fixings. (This may require two people) 3. 3. If wall tiles have been installed, drill 8mm holes through tiles to reduce the pressure on the tiles and reduce the chances of cracking tiles. Drill 6.5mm holes into brickwork ensuring it is deep enough to take 25mm green plug and 50mm screw. 4. Install 25mm green plug into hole and push into hole past the depth of the tiles to prevent any pressure on the wall tiles. 5. Hold rail in position and install required number of 12G x 50mm stainless steel security screws. (Refer to list below for number required) 6. The junction between rail and the wall is to be sealed with anti-pick sealant. IMPORTANT Position of the Anti-ligature rail is critical to comply with standards Australia AS 1428.1-2009 Fixing Requirements Stainless Steel Safety Screws. 300mmm Grabrail 6nr x 12G x 50mm pin hex countersunk self-tapper screws 700mm Grabrail 8nr x 12G x 50mm pin hex countersunk self-tapper screws 900mm Grabrail 10nr x 12G x 50mm pin hex countersunk self-tapper screws 30 deg Grabrail 18nr x 12G x 50mm pin hex countersunk self-tapper screws 90 deg Grabrail 19n x 12G x 50mm pin hex countersunk self-tapper screws