Craftsman 358.745191 Instruction Manual

nuts, and bolts. Replace any dam- aged, broken, or worn parts. • At the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio. OTHER • Do not store gasoline from one sea- son to another. • Replace your gasoline can if it starts to rust. TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before perform- ing all of the recommended remedies below except remedies that require operation of the unit. TROUBLE Engine will not start. Engine will not idle properly. Engine will not accelerate, lacks p ...

build up on the muffler and spark arrest- ing screen. For normal homeowner use, however, the muffler and spark ar- resting screen will not require any ser- vice. After 50 hours of use, we recom- mend that your muffler be serviced or replaced by your Sears Service Center. REPLACE SPARK PLUG Replace the spark plug each year to ensure the engine starts easier and runs better. Set spark plug gap at 0.025 inch. Ignition timing is fixed and nonad ustable. 1. Twst, then pu off spark plug boot. 2. Remove spark plug from cylinder and discard. 3. Replace with Champi ...

against the fol- lowing list. Model 358.745191 • Powerhead • Trimmer Attachment • Shield • Wing Nut (screwed onto shield) • Container of Oil Examine parts for damage. Do not use damaged parts. NOTE: If you need assistance or find parts missing or damaged, call 1-800-235-5878. It is normal for the fuel filter to rattle in the empty fuel tank. Finding fuel or oil residue on muffler is normal due to carburetor adjustments and testing done by the manufacturer. ASSEMBLY _ WARNING: If received as- sembled, repeat all steps to ensure your unit is proper ...

The trimmer head or any optional at- tachment will be spinning during most of this procedure. Wear your protec- tive equipment and observe all safety precautions. After making adjust- ments, the trimmer head or any op- tional attachment must not move/spin at idle speed. The carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the fol- lowing conditions: • Engine will not idlewhen the throttle is released. • The trimmer head or optional attach- ment moves/spin ...

READ THIS INSTRUCTIONMANUALAND SAFETY RULES BEFOREOPERATINGYOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. Assist Handle Coupler Tube Trimmer ",& ON/OFF Switch Head ark Plug Shield / Primer Bulb Line Limiter Blade Throttle Tngger ON/OFF SWITCH The ON/OFF switch is located on the trigger handle and is used to stop the engine, Move the switch to the OFF position to stop the engine. PRIMER BULB The PRIMER BULB removes air from the carburetor and fuel line ...

fuel next season. Never use engine or carburetor clean- er products in the fuel tank or perma- nent damage may occur. See the STORAGE section for addition- al information. HOW TO STOP YOUR UNIT • To stop the engine, move the ON/OFF switch to the OFF position. • If engine does not stop, move choke lever to FULL CHOKE position. ON/OFF Throttle Trigger _ \ HOW TO START YOUR UNIT _ WARNING: The trimmer head will turn while starting the engine. Avoid any contact with the muffler. A hot muffler can cause serious burns. STARTING A COLD ENGINE (or a warm engine ...