A4Tech RFKBS-27A Operation & User’s Manual
Text of the manual
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE
MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
Federal Communications Commission Requirements
The equipment has been tested and f
Turn off the power of your computer.
2.
Remove the existing keyboard (and mouse for the A4Tech® Wireless Desktop).
3.
Install the AA alkaline batteries in the Wireless keyboard. Remove the battery compartment cover on the bottom of
the keyboard by squeezing the cover in from the tab to release it.
4.
Install the AAA alkaline batteries in
Setting Up the Keyboard or Wireless Desktop
1.
Make sure that your computer is turned off.
2.
Connecting the Receiver’ s Keyboard Cable:
(a)
When connecting to an IBM AT keyboard port, use the 5-pin DIN connector already attached to the keyboard cable.
(b)
When connecting to a PS/2-style with adapter, 6-pin DIN keyboard port, it work only for the signal
Click OK and follow the instructions on your screen to complete the installation.
Selecting the Frequency Channel
The Wireless keyboard and Mouse operates on two frequency channels. To prevent interference when using two
RF Mice in close proximity a different frequency channel should be used for each mouse. Refer to the
following to change the frequency ch
