Acoustic Box 1599 Assembly Instructions
Text of the manual
Removable Front Door
1
006
007
Top Door
1
Corner Bracket
4
008
Hinge Pin
2
009/011
Door Stay / Gas struts
2
010
Door Latch
2
012
Plastic Cap
4
013
13B
Lock Bracket
2
Lock Screws
2
014
Door Handle
2
059
Top Corner Bracket LH (1600 & 1602)
1
060
Top Corner Bracket RH (1600 & 1602)
1
k
Assembly and Parts
Models 1599, 1600, 1601 & 1602
1f
!
Assembly Instructions
Models 1599, 1600, 1601 & 1602
(Parts List and Assembly on page 4)
THE
ACOUSTIC
I
I
I !
Ij--
I
I
------
005
1. Locate slots on bottom of Side (002) and Rear
(003) Panels and push down into Corner Bracket
(007).
I
I
I
Assembly Tools Required
Phillips screwdriver
Mallet
THE
ACOUSTIC
www.acousticbox.com.au
(02) 9620 5430
2. Insert Plastic Cap (012) into holes in top of
Panels to join them. Tap into place with a mallet.
3. Repeat steps 1 and 2 for all panels.
Models 1600 & 1602 ONLY:
A metal dowel stabilises the front panel (004) during
assembly. Detach dowel and discard AFTER completing
step 3.
1600 & 1602 ONLY
9.1 To hold Top Door open, swivel Door Stays into position OR
remove Door Stays from Side Panels, position them firmly
into Top Lid corners underneath flanges and re-insert back
into Side Panels.
·
4. Push Door Handles (014) into Removable Front
Door (005) until a 'click' is heard.
5. Insert Removable Front Door (005) into
Front Panel (004). Locate studs on sides of
Removable Front Panel then push slightly in
and down.
................
........
I
: 9.1:
'
'
6. Insert Door Latches (010) through holes in Top Door
(006).
7. Connect Lock Brackets (013) to Front Panel (004) by
inserting them sideways into holes. Twist into upright
position and screw into place.
8. Attach Top Door (006) to unit with Hinge Pins (008).
Tap into place with a mallet.
9. Insert Door Stays (009) into Side Panels.
To hold the lid open swivel door says into place OR (for gas
struts) please follow separate instructions packed with the
struts
Models 1600 & 1602 ONLY:
10. Insert Top Corner Brackets (059 and 060) into Side
and Front panels by Jamming in the corner and
pushing upwards.
