Dimplex Nicole Service Manual

be removed from the unit. The end bracket can be removed from the end of the Flicker Rod and the screws holding the center bracket can be removed as well. 13. Replace the old Flicker Rod with the new one and reas- semble in the reverse order. ! NOTE: Ensure that the flicker rod is not bent and the bushing in the center of the flicker rod is completely set in the support bracket. The bushing must be properly aligned for it to go all the way down into the bracket. 14. Re-assemble the remainder of the fireplace in reverse order fro ...

! NOTE: If any tie wraps were removed, replace and en- sure that none of the wires are pinched during reassembly. ! NOTE: Be sure that the flanges on the end panel are positioned on the interior of the outside panel of the fire- place. RELAY BOARD REPLACEMENT Tools Required: Phillips head screwdriver Flat Head Screwdriver WARNING: If the fireplace was operating prior to ser- vicing, allow at least 10 minutes for light bulbs and heating elements to cool off to avoid accidental burning of skin. WARNING: Disconnect power before attempting any mainte ...

be removed from the unit. The end bracket can be removed from the end of the Flicker Rod and the screws holding the center bracket can be removed as well. 13. Replace the old Flicker Rod with the new one and reas- semble in the reverse order. ! NOTE: Ensure that the flicker rod is not bent and the bushing in the center of the flicker rod is completely set in the support bracket. The bushing must be properly aligned for it to go all the way down into the bracket. 14. Re-assemble the remainder of the fireplace in reverse order fro ...

! NOTE: If any tie wraps were removed, replace and en- sure that none of the wires are pinched during reassembly. ! NOTE: Be sure that the flanges on the end panel are positioned on the interior of the outside panel of the fire- place. RELAY BOARD REPLACEMENT Tools Required: Phillips head screwdriver Flat Head Screwdriver WARNING: If the fireplace was operating prior to ser- vicing, allow at least 10 minutes for light bulbs and heating elements to cool off to avoid accidental burning of skin. WARNING: Disconnect power before attempting any mainte ...