Emerson Micro Motion ELITE Installation Manual

A B C A. Wall or flat surface B. Electronics (enhanced core processor shown) C. Flexible conduit • For mounting to an instrument pole, use a 2 in (51 mm) U-bolt pipe kit to secure the mounting bracket. Installation Manual Mounting 20002158 October 2021 Installation Manual 21 ...

A A. Detach electronics from sensor case and mount to a wall or instrument pole Procedure • For wall mounting, use four 0.3 in (8 mm) bolts to secure the mounting bracket. Mounting Installation Manual October 2021 20002158 20 Micro Motion ELITE ...

sensor in a wall mount bracket The CMFS025, CMFS040, and CMFS050 sensors have an optional wall mounting bracket. Procedure 1. Assemble the bracket. Figure 3-10: Assembled wall mounting bracket for CMFS025, CMFS040, and CMFS050 2. Attach the bracket to the wall using fasteners appropriate for the mounting surface. 3. Place the sensor into the bracket. 4. Secure the sensor in the bracket with the supplied fasteners. Figure 3-11: CMFS025, CMFS040, or CMFS050 wall mounted using bracket Installation Manual Mounting 20002158 October 2021 Installation Manual 25 ...

A B C A. Instrument pole B. Electronics (enhanced core processor shown) C. Flexible conduit Mounting Installation Manual October 2021 20002158 22 Micro Motion ELITE ...

C B A A. Direction to rotate the alignment ring B. Direction the flange bolts are pushed C. Flange bolt 6. With a wrench, tighten the nuts in an alternating order. 3.9 Attach extended electronics If your installation has a sensor with extended electronics, you will need to install the extender onto the sensor case. Extended core processors are matched at the factory to specific sensors. Keep each core processor together with the sensor with which it was shipped. NOTICE Keep the extender and feedthrough clean and dry. Moisture or debris in the extender or feedt ...

any orientation. (Some sensor models installed in very small, flexible pipeline have optional installation instructions that allow for external supports.) 2.3 Temperature limits Sensors can be used in the process and ambient temperature ranges shown in the temperature limit graphs. For the purposes of selecting electronics options, temperature limit graphs should be used only as a general guide. If your process conditions are close to the gray area, consult with your Micro Motion representative. WARNING ...

before proceeding to the next step. Safety and approval information This Micro Motion product complies with all applicable European directives when properly installed in accordance with the instructions in this manual. Refer to the EU declaration of conformity for directives that apply to this product. The following are available: the EU declaration of conformity, with all applicable European directives, and the complete ATEX Installation Drawings and Instr ...

before proceeding to the next step. Safety and approval information This Micro Motion product complies with all applicable European directives when properly installed in accordance with the instructions in this manual. Refer to the EU declaration of conformity for directives that apply to this product. The following are available: the EU declaration of conformity, with all applicable European directives, and the complete ATEX Installation Drawings and Instr ...