Contec DIO-1616RY-PE Operation & User’s Manual

The driver function library requires the initial setting to recognize the execution environment. It is called the initialization of the Driver library. When Using API-DIO(WDM) API-DIO(WDM) is initialized automatically during hardware installation. Therefore, if you want to use it with its initial settings, you can skip the setting procedure described in Step 4. To change the device name, follow the setting procedure shown below. Setting the device name (1) Run Device Manager. From [My Computer] - [Control Panel], select [System] and then select the [ ...

3. External Connection This chapter describes the interface connectors on the board and the external I/O circuits. Check the information available here when connecting an external device. How to connect the connectors Connector shape The on-board interface connector (CN1) is used when connecting this product and the external devices. CN1 37 20 19 1 36 18 21 2 Interface connector (CN1) - Connector used 37-pin D-SUB, female connector DCLC-J37SAF-20L9E(mfd. by JAE) Thumb screw : UNC#4-40(inch screw) - Applicable connectors 17JE-23370-02(D8C)-CG (mfd. by DDK, Male) ...

Environment Use this product in the following environment. If used in an unauthorized environment, the board may overheat, malfunction, or cause a failure. Operating temperature 0 - 50°C Humidity 10 - 90%RH (No condensation) Corrosive gases None Floating dust particles Not to be excessive Inspection Inspect the product periodically as follows to use it safely. - Check that the board has no dust or foreign matter adhering. - The gold-plated leads of the bus connector have no stain or corrosion. - Check that the bus connector of the board and its cable have ...

Examples of Connecting the Board to an External Device Board Input common Input Sink type output External power supply 12 - 24VDC or 24 - 48VDC Figure 3.5. Connecting the input to the sink type output Board Input Input common Sourece type output External power supply 12 - 24VDC or 24 - 48VDC Figure 3.6. Connecting the input to the source type output DIO-1616RY-PE 39 ...