Crescent SC250 Troubleshooting Manual

The machine doesn’t work as it should? The suction doesn’t work as it should? The machine doesn’t clean as it should? The brushes don’t work as they should? SC250 www.crescentindustrial.co.uk 1. Check if the battery is charged. 1. Check if the recovery tank is full. 2. Check if the battery co slot. (*) 2. Check if dirt/debris are clogging the squeegee inlet and if the blades are worn or damaged. 1. Clean it if needed. 1. Adjust the brush pressure by turning the regulation knob. 2. Check the correct installation and the wear of the cylindrical brush. 3. Check if there are external materials avoiding brush rotating. 3. Machine fault indicated by Led’s blinking. (*) (*) For these causes the maintenance procedure must be performed by an For further information refer to the Service Manual, available at any 3. Rinse the inside of the duct recovery hose with water. 3. Check if the holes in solution dispensers are clogged. Remove them and clean if needed. 3. Check if quick connect valve is not leaking. 4.