Hallco HC1BK Instruction Manual

of beer and beverages for sale. Do not use for any other purpose than the intended as this could adversely affect items placed in the unit. Beer, beverages For indoor use only. Using the unit in a location exposed to rain could result in electrical leakage and electrical shock. -­ (T@f/'>  Install the unit in a location where the floor is sturdy enough to support the load of the unit. If the floor is not sturdy enough or installation is incorrectly performed, the unit could tip over and falling shelves and products could cause personal injury. i' Store the unit in a location where it is not exposed to rain. Using a unit that has been exposed to rain could result in electrical leakage and electrical shock. Leave disassembly and disposal of the unit to qualified experts. A ROTATING DEVICE PROHIBITED Never attempt to insert fingers, sticks, etc. Into the cold air suction outlet. A circulation fan is rotating at high speed inside the outlet. Injury, electrical shock and improper operation could result. Never place heavy objects or items containing water on top of the unit. Objects could fall down and cause injury and spilled water could deteriorate the insulation of electrical components and result in electrical leakage. er. CAUTION AGAINST EXPLOSION If you find any gas leakage, do not touch the appliance .and open the door for ventilation.Gas leakage can cause explosion, fire, and fire injury. 0 0 Keep away from hot air sources Cooling performance is reduced if the unit is placed near heat sources such as hot plates and stoves and if it is exposed to direct sunlight. Should the unit need temporary storage, make sure not to store the unit in a location where children play and take precautions so that the door cannot be completely closed. This will minimize the risk that a child becomes trapped inside the compartment. 2

WELL VENTILATED PLACE Ensure at least l 0cm space between the appliance and the wall. Less than this will reduce the cooling capacity. more thanl 0cm PROHIBITED DON'T PINCH FINGERS 0 Never hang from the door or climb onto the unit. The unit could tip over or fall and cause material damage or injury. Grasp the handle when closing the door. Holding at other positions could result in pinched fingers and injury. When disconnecting the power cord plug from the wall outlet, hold at the plug main body close to the outlet. Pulling the cord could cause wire breakage, possible resulting in overheating and fire. ff@] PROHIBITED Do not throw items onto the shelves and do not place items totaling more than 30Kg on eachshelf. The shelf could fall down, possibly cause injury. 3  DANGER OF ELECTRICAL SHOCK tt DISCONNECT POWER CORD PLUG FROM WALL OUTLET Do not touch 0 0 If installation in a damp location is unavoidable, also install an electrical leakage circuit breaker. If no electrical leakage circuit breaker is installed, electrical shock could result. Disconnect the power cord plug from the wall outlet before moving the unit and make sure that the power cord is not damaged during transport. A damaged power cord could result in electrical shock and/or fire. Do not push hand against or apply excessive force to glass surfaces as the glass could break and cause injury. Make sure that the unit does not tip over or fall when it is moved. A falling unit could cause serious injury. Be sure to attach and secure shelves correctly. An improperly attached shelf could fall and cause injury.

BEFORE USE • Remove shipping package, tape, etc, and leave doors open for a while. • The unit is cleaned before shipment. However, please clean the compartment interior after delivery. • Please insert power supply plug into the wall outlet. • Allow the unit to operate for about l hour to reach temperature before placing items in the cooler. WAIT 5 MINUTES OR MORE BEFORE RE-STARTING • Restarting the unit immediately after it has been turned off may cause fuses to blow and activate the circuit-breaker, the compressor may be overloaded, and/or other damage may occur. TEMPERATURE ADJUSTMENT • The thermostat was adjusted using temperature at factory. To adjust it, turn right to reduce temperature. To raise the temperature, turn it left. Excessive refrigeration will increase electricity consumption unnecessarily. DRAIN TRAY • Defrosting is performed automatically and drain water is collected in the drain tray. • Water in the drain tray is evaporated automatically. In humidity, there may be a large amount of water in the drain tray, so please throw away drain water once a day. EFFICIENT USE Please follow the below instruction, you could save energy. • To prevent cold air from escaping, open and close the door quickly and keep the door opened for as short a time as possible. • Please install the unit in the place which is well-ventilated. SHELF HEIGHT ADJUSTMENT The shelf height can be adjusted. Arrange the shelves in accordance with the dimensions of the items to be placed in the cooler. 4

PLACING ITEMS IN THE CABINET This appliance employs a forced circulation of cold air system. If circulation of cold air is obstructed, the items will not be adequately refrigerated. Pay attention to the following points: • Do not let items obstruct the cold air inlet and suction outlet. • Place items so that they do not protrude from the shelves. The gap between the shelves and the • door is used for circulation of cold air. • Place items evenly on all shelves. Please do not display goods on the bottom. Please put goods on the shelf. THERMOSTAT INSTRUCTION Operation Control Panel The control panel is located below the doors on the front of the appliance. Turn On I. Turn the Power switch On. I. Set the temperature to the desired setting (see below). 2. Close the door of the appliance. 3. Connect the appliance to a mains power supply. Cooling Light Defrost Light CD Note: The Cooling Light is illuminated when the appliance is chilling the interior cabinet. 4. Turn light switch On [I] or Off [O] as required. Set the Operating Temperature I. Press the 8 button. The display will flash. 2. Press the Y or Z buttons to display the required temperature. 3. Press the 8 button to store the temperature. Manual Defrost Cooler feature an automatic defrost. However, should the appliance require an additional defrost period press and hold the [ button for 6 seconds. Automatic defrost cycles are every 6 hours and last 20 minutes (factory defaults). To stop the Defrost press and hold the [ button for 6 seconds. CD 5 Note: If a manual defrost is started this resets the automatic defrost timer. During defrost periods the Defrost light is illuminated.

Short - circuit and electrical shock could result. WARNING • Clean the cooler regularly to keep it clean at all times. • Never use polishing powder, soap powder, benzine, oil or hot water as these will damage the painting and plastic components. 2 CHECKS To ensure the safety, perform the following checks after cleaning.  [lJ(iJ@[i](i] els the power cord plug firmly inserted into a dedicated wall outlet? Confirm that the plug is not abnormally hot. eCheck the power cord for cracks and damage. Should the slightest irregularity be observed, contact the dealer from whom you purchased this unit or our customer's service. IN CASE OF THE FOllOWING l POWER FAILURE Keep opening and closing of the door to a minimum. Avoid placing new items in the cooler as this will raise the temperature inside the compartment. 2 WHEN NOT USED FOR A LONG PERIOD Remove all items from the compartment and disconnect the power cord plug from the wall outlet. Clean the compartment interior and wipe away all water. To prevent mold formation and bad smell, leave the door open to dry the compartment completely. 3 TRANSPORTATION Disconnect the power cord plug from the wall outlet. When moving the cooler, make sure that the feet do not damage the power cord. Do not let the feet hit against floor steps, thresholds, etc. 4 TEMPORARY STORAGE Affix a piece of wood, etc. Between the door and main unit to prevent complete closing of the door. Make sure not to store the unused cooler at a location where children play. Should a child enter the compartment and the door is closed, the child may not be able to open the door from the inside. INSTRUCTION MANUAL BEFORE REQUESTING SERVICE Please check the following items if you encounter problems with the unit. If the problem continues after taking the proper remedial actions, disconnect the power cord plug from the wall outlet. Transfer the items stored in the cooler to a box or other container. Then contact the dealer from whom you purchased this unit and be ready to provide information as listed in "REQUIRED INFORMATION" below. & CAUTION To prevent any electrical shock hazards, do not disconnect the power cord plug from the wall outlet with wet hands. 6

[email protected] or 01296 663400 R H Hall, Hallco House, Beacon Court, Pitstone Green Business Park, Pitstone, Bedfordshire, LU7 9GY 7