Starline PW1C Operator's Manual

8 Installation Checklist Check Notes DELIVERY SUPPLIED COMPLETE? CHECK THERE HAS NOT BEEN ANY TRANSIT DAMAGE POSITION LEVEL AND STABLE? ON SOUND, WATERPROOF, SELF-DRAINING FLOOR WATER ISOLATOR VALVE FITTED? ACCESSIBLE, ALL FITTINGS SOUND, AND NO LEAKS TEMPERATURE CORRECT? %1.& 9#6'4+0.'6Ĺ%*16 9#6'4+0.'6Ĺ% PRESSURE CORRECT (200 – 350 kPa)? LIMITER FITTED IF ABOVE RANGE FLOW RATE CORRECT? COLD ≥5L PER MIN, HOT ≥20L PER MIN QUALITY WITHIN REQUIREMENTS? FILTER OR SOFTENER IN PLACE IF OUTSIDE REQUIREMENTS POWER ISOLATING SWITCH? FITTED, FUN ...

• Install machine on sound waterproof self-draining floor and use adjustable feet to level machine. NOTE: Failure to level the machine correctly may result in leaking during the cycle, overflowing from the door sill, poor hygiene through the wash tank not being able to drain correctly, and/or visibly uneven door. • Allow room for detergent to one side of machine or in adjacent cupboard. 20 litre container requires approximately W 250mm x D 350mm x H 450 mm. Ventilation • The PW1C includes an integrated heat r ...

13 Accessories PW1C Accessories • Part #: PW1C AC • Date: 26/11/2018 • Version: 1-C ...

2 Warnings Before installation and commissioning, you must read the safety instructions and warnings carefully and all the warning labels attached to the equipment. Equipment contains dangerous voltages and can be hazardous if installed or operated incorrectly. Non-compliance with warnings or failure to follow the instructions contained in this manual can result in loss of life, severe personal injury or serious damage to property. Before installation or repair, you must read the instructions and warnings carefully and all the warning labels attached to ...

5 Installation Diagram PW1C Installation Diagram • Part #: SPW10021 • Date: 12-02-2019 • Version: 3-C ...

• Turn Cycle Selector to 0 and turn off the power from the wall. • Remove Scrap Trays (3) and Upstand (2) to drain the Wash Tank. • Once the Wash Tank is fully drained remove and rinse Wash Pump Filter (1) before replacing back into the machine along with the Upstand (2) and Scrap Trays (3) . CLEANING – AT LEAST ONCE A WEEK Remove, rinse and replace when machine has cooled down: Wash Pump Filters 1 Drain Upstand 2 Scrap Trays 3 Wash Arms 4 Rinse Arms 5 Inspect and clear all jets in the upper and lower Wash/Rinse Arms using a small object such as a toothpick wher ...

12 Schematic Diagram AL8C(S)/PW1C Schematic Diagram • Part #: 010186 • Date: 19/07/2018 • Version: 1-B ...