Speco O4VB1M Quick Start Manual

■ If the product does not work properly, please contact your dealer or the nearest service center. Never attempt to disassemble the camera yourself. Any unauthorized changes or modifications could void the warranty. ■ Do not allow water or liquid intrusion into the camera. ■ All installation and operation here should conform to local electrical safety codes. Make sure the device is firmly installed on the wall or ceiling. ■ Do not use camera beyond specified voltage range. ■ Do not drop the camera or subject it to physical shock. ■ Avoid touching the camera lens. ■ If cleaning is necessary, please use cleaning cloth to wipe it gently. ■ Do not aim the camera at the sun or extremely bright light sources. ■ Do not place the camera in extremely hot or cold environments and dusty and damp locations. Do not expose it to highly electromagnetic radiation. ■ Do not block any ventilations. Package 2

CD Plastic plug × 4 Junction box 4 tapping screws Overview 3 Drill Template 1 2 3 5 4 6 Fixed ring Micro SD card slot Ethernet connector DC power connector Mounting base Reset 1 machine screw Rubber plug 1 2 3 4 5 6

* 2 DC 12V power supply is not required if a PoE switch or injector is used to power the camera. ► Connecting Network Cable ① Loosen the nut from the main element. ② Run the network cable (without RJ 45 connector) through both elements. Then crimp the cable with RJ 45 connector. ③ Connect the cable to the hermetic connector. Then tighten the nut and the main cover. 2 1 3 Security cap DC12V

to withstand three times the weight of the camera. ① Open the mounting base and the upper cover of the junction box. ② Install junction box onto the wall by using the screws provided. ③ Mount the rubber plug to the gap of the mounting base and fasten the camera onto the mounting base. Mounting Base Upper Cover

box as shown below. Connect the cables and then i ⑤ Bracket Adjustment-Loosen the fixed ring to adjust the view angle of the camera. After you get the optimum angle of view, tighten the fixed ring to complete the installation. Rubber plug

MAC address of each device. Select the applicable device and double click to open up the web viewer. You can also manually enter the IP address in the address bar of the web browser. Web Operation and Login 5 ● Operation IP Scanner can search for the device on the local network. ① Make sure that the camera and the PC are connected to the same local network. The camera is set to DHCP by default. ② Install IP Scanner from the CD and run it after installation. Fixed Ring Pan 360° Tilt 90° O4VB1M

password is 1234. After logging in, follow directions to install applicable plugins.