Pipeline P-DR1W-48 Owner's Manual

ensure a maximum opening and closing range. Ensure that the sliding door gasket (9) is forced against the wall. HOURS Apply silicone between the bottom of the fxed panel and the threshold of the base. Silicone application along the length of the threshold is also suggested. In both cases, it is done from the outside of the shower area. 3 DOOR OPEN DOOR CLOSED APPROX. 3” (76.2 mm) 7 6 9 3 12 SILICONE ...

1 PARTS LISTING ........................................................ 3 PROVIDED HARDWARE ............................................... 4 GLASS PANEL DIMENSIONS .......................................... 4 REQUIRED TOOLS AND MATERIALS ................................. 4 GASKET INSTALLATION............................................... 5 RUNNING RAIL. ....................................................... 6 GLASS HOLDERS ...................................................... 7 GLASS CLIPS ........................................................... 7 FIXED PAN ...

(6), closest to the side where the handle is locat- ed. Apply the door gasket (9) to this edge of the sliding door. 10A Install door side gasket (16) onto slidind door panel (6). 10B 9 6 16 16 16 6 1/2” (12.57 mm) 17 6 10A 10B INTERIOR SHOWER SIDE BOTTOM TOP ...

SHOWER ENCLOSURES P002 IT IS MANDATORY TO HAVE A WALL STUD ON EACH SIDE OF THE SHOWER UNIT TO SECURELY FASTEN THE RAIL TO THE WALLS. 07.08 OWNER’S MANUAL P-DR1W-72 ...

illustrated. Secure them temporarily in place. Position the wall brackets (2) on the running rail (1) as illustrated. Secure them temporarily in place. 1 4 ...

tangent to the running rail (1). See sheet for installation and install the handle as shown. CONTINUED 8 Through the use of the nonconcentric washers, adjust rollers so that the sliding door panel is parallel to the running rail. 8C Model illustrated B GLASS HOLE 5 1 8 WASHER 5 WASHER ...

1 12 6 11 BOTTOM 11 DOOR SIDE GAS KET 11 Install door side gasket (12) onto sliding door panel (6). 12 1/2” (12.57 mm) TOP 6 12 ...

ensure a maximum opening and closing range. Ensure that the sliding door gasket (9) is forced against the wall. Ajuster le positionnement des butoirs (3) afn d’obtenir une ouverture ainsi qu’une fermeture optimale de la porte coulissante. Assurer que le joint de rétention (9) de la porte coulissante s’écrase contre le mur. Apply silicone between the bottom of the fxed panel and the threshold of the base. Silicone application along the length of the threshold is also suggested. In both cases, it is done from the outside ...