Silentnight divan Assembly Instructions Manual

packaging. To avoid risk of suffocation, please ensure that the polythene bag is well out of reach of children. The polythene bag is recyclable. 2. Remove any proud packaging staples. 3. Stand the divan vertically on the short side. 4. Before cutting the strap, please note that the lid will open automatically. Allow sufficient space for the lid to open. 5. Cut the strapping. 6. Remove castor pack from inside the Ottoman ensuring all packaging staples are removed and insert the castors/glides/legs. 7. Attach both ba ...

maximise your bedroom space. To get the best out of your new bed please follow these instructions at all times. ...

a mattress on the divan base. • Never allow children or pets to play on or inside the Ottoman divan base. • Stand clear when opening or closing the Ottoman divan base. • Ensure bed linen does not get caught within the recliner mechanisms. • Close the Ottoman divan base by pushing down with both hands centrally on the mattress. • Do not operate the mechanism while the bed is being used. • Maximum loading weight is 40kg evenly distributed. ...

· 2x Medium/Large Posi and/or Flat-head screwdriver or similar · Wooden/rubber mallet · Large bradawl or similar · Scissors To avoid the risk of injury, it is recommended that a minimum of two people assemble and install this product. Castor/glide connection 1. Remove the fittings bag/instructions, and cut the lid ties. Care should be taken as the lid will try to open. 2. Close the lid and turn the base on to its side. Locate and hammer home the 4 castors/glides into the corner sockets. 3. Turn the base so it is sittin ...

maximise your bedroom space. To get the best out of your new bed please follow these instructions at all times. ...

outer sides of each base unit (blue arrows) and fit the beige plastic hole plugs. Remove the ‘Pierce Here’ labels from the outside of the base units. 2. Identify the 2 drilled connecting holes on the inner sides of each base unit (red arrows) identified on the outside of the base by ‘Pierce Here’ labels which should be removed. Using the large bradawl, pierce the fabric and make a hole large enough for the ‘female’ connector in all 4 aligned holes. 3. Push both base units together and align. ...