DAVIS Metric Rain Calibration Insert Setup Instructions

3465 Diablo Ave., Hayward, CA 94545-2778 METRIC RAIN COLLECTO R SETTINGS ADDITIONAL S ETUP INSTRUCTIONS FOR VANTAGE PRO Metric Rain Collector Settings Use this procedure to set up your rain collector and Vantage Pro con- sole for viewing rain collection data in millimeters. 1. During setup configure your Vantage Pro console for the .01 inch rain collector. Although the console Setup Screen 12 allows you to select either .01 inch, .2 mm, or .1 mm rain collector, all Van- tage Pro rain collectors are currently calibrated for .01 inch. Note:Do not select .2mm in the console Setup Screen 12. To Display Rain Data in Metric Units on the Console Use this key sequence to change the Rain data units displayed on your console: 1. Press the Rain key 2. Press the 2nd key. 3. Press the Units key. 4. The units used to display Rain data will toggle between inches and millimeters each time you repeat this key sequence. Note:The Vantage Pro rain collector measures rain in .01 inch increments. When you select metric units for display, .01 inch increments are con- verted into millimeters. Console Setup Screen #12: Use the “.01 IN” Rain Collector setting. RAIN DAY RAINYR Press this key to select Rain LAMPS 2ND Press this key to use “secondary” key value UNITS GRAPH Press this key to change the Rain display units 07395.165 (Rev A, 11/09/01) © Davis Instruments Corp. 2001. All rights reserved. Product #6310, 6310EU, 6310UK, 6310C, 6310CEU, 6310CUK

1. In the Weatherlink Software, select the “.01 in” rain collector in the Station Config dialog box found in the Setup menu. Note:Do not select .2 mm or .1 in in the Station Configuration dialog box. The .2 mm and .1 in settings are not currently supported by the rain collector shipped with Vantage Pro . 2. Select “mm” for rain in the Select Units dialog box. Use the “.01 in” Rain Collector setting. Select the “mm” set- ting for Rain in the Choose Units dialog box.