dbx DriveRack 260 Manual 

ro.com • URL: http://www.dbxpro.com rks of their respective companies. Performance: dbx Type IV conversion system mic Range line: >114 dB A-weighted, >112 dB unweighted IV Dynamic Range: >119 dB, A-weighted, 22kHz BW >117 dB, A-weighted, 22kHz BW le Rate: 48kHz Performance: mic Range: 112 dB A-weighted, 110dB unweighted em Performance: mic Range: >110 dB unweighted, >107dB weighted +N: 0.002% typical at +4dBu, 1kHz, 0dB input gain uency Response: 20Hz – 20kHz, +/- 0.5dB channel Crosstalk: >110dB, 120dB typical talk Input to Output: >100dB y Agency Approvals: 500, IEC 60065, EN 55013, E 60065 DriveRack™260 Complete Equalization and Loudspeaker Management System www.dbxpro.com ngs 18-0152 -A 9/02 The System Solution The Professional’s Choice In Signal Processing™

• Advanced Feedback Suppression™ (AFS™) • 2.7 Seconds of Configurable Delay • RS-232 PC GUI control • Graphic and Parametric EQ • Classic dbx® Compression and Limiting • Wall Panel Logic Control • Full Bandpass and Crossover Filtering • Open Architecture Routing Configurations • Auto Gain Control • Full-time RTA • Independent Output Processing • Setup Wizard with JBL® and Crown® Components • Auto-EQ Function • Security Lockout • Flash Memory – No Battery Required • Type IV® A/D Conversion • >110 dB Dynamic Range Stereo Bi-Amped with Dual Delays Stereo with Four Auxiliary Zones All parameters, functions, and utilities can be accessed from both the Front Panel and the PC GUI. Password Security can be used to lock access to the parameters or functions. Programs can be stored to the unit and to the computer for nstant recall, editing, or even off-line editing. The 260 provides both Input and Output EQ. Input EQ is switchable between a 9-Band Parametric or 28-Band Graphic, the Output EQ is a 4-Band Parametric EQ. There are two Insert Positions in the Input section that allow the following DSP modules: AGC, Advanced Feedback Suppression™, SubHarmonic Synthesis, Gate, Compressor, Notch Filter or Wire if no additional processing is desired. For Dynamics control, the 260 offers a classic dbx® Compressor, Gate or AGC in the Input Insert Section, while a Limiter or AGC is provided on each output for system protection. The DriveRack™ 260 offers up to 2.7 Seconds of Delay. The Delay is config- urable with both the input and output sections offering Delay modules, so you can put the delay where you need it. Outputs offer both output Polarity and Phase control. The DriveRack™ 260 Crossover section provides Bandpass and Crossover filters with slopes up to 48 dB per Octave, and Bessel, Butterworth, and Linkwitz-Riley filter topologies. Stereo Tri-Amped